octavianx

For me 1941 is flawless, no comparison towards old release

Kodiaq was refreshed outside but under the bonnet it is 2016 vw technology. Old crap tbh..... No sense at all to compare it to octavia. When they build kodiaq on octavia platform then we can chat. For now it is old sweet in new package.

Mate set hcvariant to 1. You loose travel assist but lane assist still works with the.button on the steering wheel, acc still works well with just hands on the wheel.and no errors on VC. Mate set hcvariant to 1. You loose travel assist but lane assist still works with the.button on the steering wheel, acc still works well with just hands on the wheel.and no errors on VC.

Fully agree, I have the same as sfd is needed to code 19. All works well without coding 19 and sfd trace left

Looks like 1.5-2k E damage. New bumper for sure, paint, maybe sensors. This is just outside. 99% you will find damage under the bumper as all the pressed out lines usually come from the reinforcing parts underneath.

No probs, enjoy. In case it gets crazy with throwing a usual missing TA error set hc variant to 1. Capacitive wheel works as designed, car will start in traffic, sense the touch etc. But you will have mid travel assist, no errors and beeps though.

Same here obd11, my module 13 has exact same HW/SW values, just checked, not a single difference.

Just dectivated it all and set back afterwards as I wrote. All worked. The only mowent when I was able to replicate your message with something wrong was when I made 2 changes at once in 13. Doing them separately worked. When I enter 20103 I change 1 codign. Save it. Then 20103 again and second coding. No other ideas mate....

Security code? Try with this when coding 13

Check if all below is done : Select Driver Assistance A5 - Select Long coding - Select KLR - Set to Coded - Select Point of intervention - Set to Early - Select HC Warn Intensity - Set to Setting_over_menu - Select HC variante - Set to Variante_2 - Select Adaptive cruise control 13 - Select Long coding - Select Capacitive_sterring_whell - Set to Installed - Select Travel Assist - Set to Activated - Select Gateway 19 - Select Adaptation - Select Specified installation of sub-bus users - Select Control module for sterring whell touch reconition - Set to Yes Last one needs sfd, I have skipped it an despite having same error U112500 it all works.