Marcii

The doors module

I dont have memory seats 😳 It will work but not fully like bmw only 1-2mm willl drop, because i think the BCM its Mid no high

Have you try this? mirror switch has to be on the passenger setting for it to work. 52 Passenger door 07 coding Byte 4 Enable bit 2 and 3 THEN 1. 09 Central Electronics 2. 31347 Adaptations 17-Access control 2 Spiegelabsenkung bei Rueckwaertsfahrt (change to "active") (22) Access control 2-Menuesteuerung Spiegelabsenkung (change to "active*) this puts the option in the menu screen.

You know this ?? when you drive the car at night and activate the high beam...the low beam rises higher for better visibility, after you turn off the high beam, the low beam goes down to its initial position

In the end I don't have any errors anymore but what bothers me is the fact that the headlights don't move up and down when I turn on the basic settings.

I did, "Acknowledge" runs to the end as well as "Resetting counter for headlight range adjustment" only basic settings remain active or on vcds running

I did this, but the problem is that in basic settings it remains active.

hello everyone, I own a skoda octavia 3 vrs 2018 facelift and I bought the car with sports suspension, that is, h&r 40mm sports springs, the problem was with the headlights, they were too high, I also went to skoda to solve the problem but without success they said to put the suspension back in place... several searches on the internet I found that the sensor rod must be replaced with an adjustable rod, I changed the rod, I brought the sensor into working range, I try to do basic settings from the electronic control unit or from hex4b but it doesn't work..it stays stuck on active in obd11 and in vcds it stays on running, it doesn't change... I also entered live data Level control system sensor Left Rear Level Control System Sensor, PWM signal 40.30 % -should I increase the percentage to 50?? and here at "Leuchtweitenregulierung" SLWR verbaut Not installed is it normal?? Ps:one more thing, I manually adjusted the headlights so as not to blind other traffic participants I noticed that Skoda has a very interesting function (but it doesn't work for me)...when you drive the car at night and activate the high beam...the low beam rises higher for better visibility, after you turn off the high beam, the low beam goes down to its initial position

i solved the problem with a emergency recovery and the firmware must be the same when the unit was stuck... now works perfect, no errors, no problem

I made a mistake, I put the latest version of the software on the card, everything went perfectly, but I had a problem with navigation, when I put the address and started it, after 5-10 seconds I got an error "Navigation database not available", I wanted to go back to the initial version and put the old software on the sdcard and entered swdl, I checked the box, I started the download, I selected all, but the problem is that I did not deselect emergency, hmizr, etc., I wanted to do the same thing with the laptop and emergency download but I can't... is there anything i can do to recover it?? , please help me

mst2 technisat

i downloaded from vw because from skoda the servers always crash i always download from vw tiguan 2019 discovery media and works good...after i made firmware update..i had this problem

hello everyone can someone help me please. I updated the firmware unit and updated the maps...but after entering an address and starting it, after a few seconds I get this error "Navigation database not available"

Hello everyone, I have a Skoda Octavia 3 vra 2018 facelift mib2, and since I got the car this menu is missing from the navigation, can someone help me activate it back. the picture is just a sample

I changed the oil....the old owner changed the oil in 2022, the date was written on the oil filter...but the problem is that in the old oil I found very fine metal...the oil it was pretty clean...the filter also clean...and I did not see any metal particles on the filter

in my old Tiguan, I changed the oil 2 times... only that in the dq500 you have to let go of the oil from the mechatronic as well

the procedure is the same for skoda octavia 3 vrs 2.0 tsi 2018 Dq250 02e?? and I also want to ask before changing the oil, must the oil be heated to 35-40 degrees and then replaced??? or can it be done after the car has been in the garage for 1 night??? and then after it is replaced and all the procedures are done and when the temperature reaches 35-40 you do the level right?? on dq500 0bh vw tiguan 2018 this was the procedure you heat up the oil 35-40 change all...and when the new oil reaches 35-40 you do the level

My headlights also have a cornering light function but the problem is that it doesn't make that much light and the range is small

I am from rostech you helped me with this problem with cornering...all works perfectly....

I'm sorry if I annoyed you... yes, you're right, what I changed above has no relevance to my problem 🫣🫣

have you tried basic settings on the gearbox in the apps>workshop>basic setting of transmission section??

What you use obd11 carista vcds ??

First look if all its the same i have octavia rs 2018 full led headlights and fog lights led

For me this works 💪 because on my octavia not worked the fog lights when i turn steering wheel or turn signal Code: ENG116948-ENG116105-Leuchte12NL LB45-Dimmwert AB 12 from 100 to 0 ENG116948-ENG116104-Leuchte12NL LB45-Lichtfunktion B 12 from Abbiegelicht links to not active ENG116949-ENG116124-Leuchte13NL RB5-Dimmwert AB 13 from 100 to 0 ENG116949-ENG116123-Leuchte13NL RB5-Lichtfunktion B 13 from Abbiegelicht rechts to not active ENG116944-ENG116028-Leuchte8FL LB39-Lichtfunktion B 8 from Abbiegelicht links to Standlicht allgemein (Schlusslicht: Positionslicht: Begrenzungslicht) ENG116945-ENG116047-Leuchte9FL RB2-Lichtfunktion B 9 from Abbiegelicht rechts to Standlicht allgemein (Schlusslicht: Positionslicht: Begrenzungslicht) Then try changing the fog light channels instead: Code: ENG116940-ENG115952-Leuchte4TFL LB4-Lichtfunktion B 4 from not active to Abbiegelicht rechts ENG116941-ENG115971-Leuchte5TFL RB32-Lichtfunktion B 5 from not active to Abbiegelicht links ENG116938-ENG115914-Leuchte2SL VLB10-Lichtfunktion B 2 from not active to Abbiegelicht rechts ENG116939-ENG115933-Leuchte3SL VRB21-Lichtfunktion B 3 from not active to Abbiegelicht links And a few config bits: Code: IDE03638-ENG116677-Stationary cornering light-Abdimmgeschwindigkeit from 0.0 %/s to 25 %/s IDE03638-ENG116676-Stationary cornering lamp-Upper speed threshold from 127.0 km/h to 40.0 km/h IDE03638-ENG116674-Stationary cornering lamp-Vorschrift from SAE J582 to ECE R119

you have led fog lights ???