pmdc199

All pics here, to large to upload https://www.dropbox.com/sh/dhx69601j4u898t/AAAeRB7h3kUVSOK5zGlZ7flna?dl=0 These came off my OCTAVIA 2010 VRS which I have sold. I used to swap them each year. Tyres are all very good condition. Bought new in 2014, not used since 2018, been stored in garage. Alloys are generally in good condition. One is kerbed and could be used as is or improved - Pic 3 bottom right, Pic 4 slight mark on left (below) I have put in lots of pictures of each wheel to show true representation. Part = 5E0601025AC ET51 5x112 Fits Many VAG cars not just Octavia 2 and 3 GARAGE CLEAR OUT SO QUICK SALE £200 for all Gatwick based - collection, or if full price paid willing to drive them up to 1 hr each way

wow, that’s good. my 4 wheel hunter was 70 quid.

not 1Z3? The bilstein web catalogue

I put Bilsteins front and rear. So much nicer. Not the cheapest shock but, good. Rears were 92 delivered https://www.ebay.co.uk/itm/231490959426

Sorry pressed submit. My shocks on rear on my 2010 were shot. Could push them all the way in and no damping. Bilsteins now, like a new car.

The vrs ones ones are shorter than normal. I changed mine. Like you say 118mm I used these, not the best but here is the part number under OE on site https://partsfinder.bilsteingroup.com/en/article/febi/23504

I did not do any bushes, all seemed ok. I have stopped now. No money left and soon the new bits worth more than the car

i took my whole strut and hub unit off. Much easier to work on imho. i got a hunter 4 wheel yesterday too. Quite a way out. But I did tie rods too

do you know who vag use as OE?

what discs and pads did you use. I used Pagid, but disc rusting already. are they poly bushes

I found the strut spreader tool was junk. My metal too old and just crumbled. Used a chisel in end. Not ideal. What did the garage want labour wise to sort the strut?

Sorry, being thick. Yes seen that happen with ball joint. I replaced them too, wheel bearing and struts and coils and top mount. The nearside strut was a pig for me. I had to remove it as would not go all way in. Then sand all the rust away at base of knuckle. Might get a Dremel for next time.

It's so frustrating Did the ARB link snap off the ball joint? If so, while I was looking for ways to solve my problem I came across this idea (second half of video) where it shows putting a groove into the ball to get some grip.

In the end, even caliper off not enough space to drill out. A decent set of lock pliers did the trick.

It’s a triple square, or it was 😂. might leave it, or get a dremmel. Just a pain in butt on axle stands to get under.