chris-H

Afternoon all Sooo the other evening the clutch pedal went straight to the floor and stayed there. There was brake/clutch fluid around the slave cylinder bleeder on top of the gear box and it was obvious the rigid hyd pipe had disconnected from the t-piece. The retaining clip that should hold the pipe in place was rusted and kaput sooo a new one is required. Does anyone know where to source a replacement clip ? TPS / Skoda only supply the clip as part of a complete t-piece assembly. £50 is alot to pay when only the clip is needed ! Thanks - Chris

As the title states... Hope this gives some light relief on first days back to work for most ! Basically just returned from a great weekend of climbing in sunny Yorkshire. Managed to find a set of OM roof bars last week on the bay of e and also got myself a roof box. Living the dream, love my rs even more now . However check out the dents down the side ... beware of angry sheep attacking their reflection in your once mint bodywork ! If i hadnt seen it with my own eyes I'd have thought my car had been vandalised lol. ( which it has but by a sheep ) Baaaaaloks, Chris

Morning all, I've managed to break 1 of the 2 lugs on the airfilter housing lid on my 2006 Rs. These things cost a small fortune to buy new! Does anyone know if the polo Airbox is compatible, there are plenty on ebay although the lid does look slightly different. Vrs part no 6Q0 129 607 AJ POLO part no 6Q0 129 607 AR Thanks, Chris

Thanks Guys managed to source 1 new. TRW replacement for Leon Cupra R, in red but whose looking ?!! These are officially now like rocking horse sh.. at least 2 weeks backorder from TPS Best regards Chris

Looking for NS REAR brake caliper carrier?

Desperately need vehicle models / part numbers for the 256mm rear NS brake carrier options on the VRs. Currently car stuck on ramp with a sheared slider pin typing this on phone ..100 miles from home Carrier to replace part number 1U0615425 from mk1 Octavia RS Or anyone have 1 spare ?? Yes I've found the big brake thread but struggling to suss out the correct options Many thanks Chris

Thanks Glassy should have been clearer.. The "current replacement" that is fitted (badly) is a TPS supplied VW screen, stamped VW in bottom corner. I have a choice once this is removed of the same, without seal/gasket or of a Pilkington supplied as pictured by yourself. One issue that has come to light is that the current batch of TPS supplied screens apparently have some distortion (very slight inward warping) centre of the top edge. This has been stated by VW technical peeps. In fairness I didn't notice this with the one fitted currently. BR Chris

sent !

Sorry for the delay in getting back to you guys , finally managed to get the car back to the fitters .. I've a choice between the tps OEM supplied screen which no longer come with the seal (pre 2006) or I can get a Pilkington glass replacement which does come with the original seal . VW no longer supply the rubber seal ?? Glassy , what are your thoughts ? Any advice appreciated

Something amiss , I was called by the company on Friday and they've taken the photos to look into. I'll keep u posted, the guy in the phone agreed it's not been done right ! Merry Christmas

Yes it is !

I shall try and find out tomorrow... my niggle is that my screen was broken on company business so this has gone through a large national repair company ,they're being less than helpful to say the least .

So potentially it's sat too high on the adhesive and maybe they've been a little heavy handed with the cutter ? !!

Thanks, I'm asking what's been done or removed from experience before I complain . Ive had the car years but never looked in that area until now !! I know some of the earlier windscreens had the encapsulated seal around the glass .