Hi folks

I need to replace the driver side window regulator in my 06 Superb

Tried searching here for a guide but it all seems so confusing

I can get my hands on an OEM part from TPS which i presume will come like the one pictured in the link below but any info on fitting would be appreciated.

Does the OEM part come like this or is it just a smaller part?

I can remove door card ok but some people say i need to drill rivets when replacing regulator etc?? Confused!!!

Any pointers gratefully accepted !

The image shows passengers side however i need to replace drivers side

Link as follows http://cgi.ebay.co.uk/02---08-SKODA-SUPERB-LEFT-HAND-FRONT-WINDOW-REGULATOR_W0QQitemZ320427092757QQcmdZViewItemQQimsxq20091122?IMSfp=TL091122177001r35781

Edited 19 January, 201016 yr by piratez

Hi there done one of these a few months ago.If the part is supplied with the back plate it makes things a LOT easier as the new one bolts straight on.You have to transfer the window motor from the old panel and put into the new one - three screws if i remember correctly.The job took me a couple of hours and was more fidly than difficult.I remember my mechanic saying he didnt want to touch it because of the drilling you mentioned so i presume sometimes the part comes as just the mechanism which has to be riveted back on.

ps is the drivers window switch sticky? i went and replaced the regulator only to find out the switch was at fault

Edited 21 January, 201016 yr by BXR770

Thanks for reply - definetly the regulator ,it has that horrible noise when switch is depressed!!! Must be the cable snapped inside

Edited 21 January, 201016 yr by piratez

you only have to drill rivots out if the part dont have the silver backing plate, you can buy these parts from german swedish and french for £40 or pay £70 plus vat, these are recommended as the just fit directly into place