I scanned the Yeti last weekend just to see if alls well but come up with this.

Monday,30,August,2010,20:43:44:42859

VCDS Version: Release 908.2

Data version: 20100326

--------------------------------------------------------------------------------

--------------------------------------------------------------------------------

Address 09: Cent. Elect. Labels: 1K0-937-08x-09.clb

Control Module Part Number: 1K0 937 086 C HW: 1K0 937 086 C

Component and/or Version: BCM PQ35 M 103 0575

Software Coding: 48180ABBF05BF1C040080080010089E4437500AE726D85605C0540000000

Work Shop Code: WSC 33361 790 00999

1 Fault Found:

02071 - Local Databus

012 - Electrical Fault in Circuit - Intermittent

Freeze Frame:

Fault Status: 00101100

Fault Priority: 2

Fault Frequency: 1

Reset counter: 131

Mileage: 2402 km

Time Indication: 0

Freeze Frame:

Term 15 Off

Voltage: 12.50 V

OFF

ON

Term 50 Off

OFF

OFF

Now Ross tech come up with this as a solution

02071 - Local Databus

02071 - Local Databus: No Signal/Communication

Possible Symptoms

Control Modules connected to Local Databus not functioning

Possible Causes

Wiring/Connectors from/to Control Modules in Local Databus faulty

Control Module in Local Databus faulty

Possible Solutions

Check/Repair Wiring/Connectors from/to Control Modules in Local Databus

Check/Replace Control Module in Local Databus

Special Notes

When found in Combination with 00153, check special notes.

Retrieved from "http://wiki.ross-tech.com/wiki/index.php/02071"

Have been to see the dealer and was asked if any warning lights were on etc and was told there diag equipment might not pick it up. I expect they could be preparing the ground but will have to see on Monday.

Any VCDS experts out there any ideas?

Cheers.

Is there a problem with the car?

If there aren't any symptoms we can't normally do anything about it. Warranty won't cover fault scanning by customers if you get me if it's not causing an issue.

These things often pop up and doesn't always mean there is an issue. Much like a PC sometimes when the system boots up one of the control units doesn't come to the party and it will log a code like that. It's probably nothing to worry about.