Hi All,

yesteday I add a new stalk with CCS on it (1K0953513G) and replaced the steering wheel contol unit with an one with CCS and multifunctional support (1K0 953 549 G).

when i start codding the control unit my horn started to play constantly. after turn-off tunr-on the ignition the system disabled the horn after 3-5 seconds.

does anyone can help me with this issue? is this a codding issue or mechanical, wiring problem?

here is the codding and the fault code of the steering wheel control unit:

-------------------------------------------------------------------------------
Address 16: Steering wheel	 Labels: 1K0-953-549-MY8.lbl
Part No SW: 1K0 953 549 G HW: 1K0 953 549 G
Component: Lenks?ulenmodul 021 0050
Coding: 0000021
Shop #: WSC 73430 790 00000
1 Fault Found
00889 - Horn (H)
	 007 - Short to Ground
-------------------------------------------------------------------------------

My car is: Skoda Octavia II (1Z) Classic 2008

I'm using VCDS with HEX-USB+CAN intraface cable

regards,

stuckoff

as an addition based on this publication http://skoda.workshop-manuals.com/octavia-mk2/index.php?id=3101 it seems that F8 is shared between horn and ccs.

what was you original slip ring and controller?

have you added mfsw?

I left them in the car, so I'll check tomorrow, but they was without MFSW and CCS.

I did not install MFSW, because the one I tryed to install was hooked and the airbag did not fit in it. i took all the parts from a crashed car and it seems that the SW was damaged during the impact.

so now i'm with the non-MFSW.

Hi again

i checked the old ones:

SW controller was: 1K0-953-549-BE

the slick was: 1K0-953-513-E