Who has fitted it?

And if so a "home job" what parts are required??

Does the chassis need notched?

Where to buy the parts?

Iv fitted it

It was a Rayvern kit fitted by me using the kit + some 5/7 core cable..8mm plastic air lines and 4mm airlines to the gauges

You dont "need" a chassis notch but it is def better to get one. Without a notch the driveshaft (drivers side) will be the 1 thing catching when driving low. Also when "aired out" the chassis will sit on the driveshaft without a notch (not good for the shaft and stops it sitting lower)

I boughty kit from another forum used but it was from Rayvern Hydraulics originally. Then i sourced the cable + piping from local electric/ airline shops

What kind of management you using??

Plus you think a 5gallon tank would surfice ??

What kind of management you using??

Iv sold the kit now but i wasnt using management.

It was "manual 2 way" so had 2 manual switches. 1 front up/down. 1 rear up/down. And 2 gauges. 1 front. 1 rear.

What was it like for cornering? Been told about 2 and 4 way

What was it like for cornering? Been told about 2 and 4 way

Was **** untill i refitted my Anti Roll Bar links (used adjustable links but mondeo ones are fine).

With the links on it cornered almost as well as coilovers

Edited 22 October, 201312 yr by mattvrestate