Not too much - just slapped some tyre dressing around the black bits and cleaned up some of the metalwork. I think I need some bling in this engine bay, but not got a clue where to start - Need some bling caps I think. Anyway, a couple of quick befores and one after shot. (as an aside, check out those pipe clips.... I was recommended to get new ones from std jubilee ones... think I went a bit ott )

theres a bailey motorsport header tank nice and shiney polished alloy but its expensive at 130 quid certainly bling tho.

Forge do caps but they a bit too TT beetle for me.

I like the scratched in VRS PD130 on the rocker cover. Anyone would think that it was a replacement engine!!

That was my mate who tippexed on the rocker cover. I scratched it off gently, but it left its mark. I need to get rid of all the green "BA" markings too long term. Damn scrappies.

http://i24.ebayimg.com/02/i/05/e7/67/48_1_b.JPG

header tank pic

http://i22.ebayimg.com/04/i/04/58/94/a6_1_b.JPG

chrome oil cap pic not a good pic

Might see if I can take my L section of IC pipework to be chromed somewhere.

Hmmmm, will have to dig out some tyre dressing now lol!

Might see if I can take my L section of IC pipework to be chromed somewhere.

cromwell tools do a polishing set for 14.99.

i polished my mates 300zx inlet and plenums and they came up gleaming for about 3 hours work. Horrible dirty work mind.

Did the BA on the front of the block used to be followed by "RRY BOY" ??

Did the BA on the front of the block used to be followed by "RRY BOY" ??

Deserves a that!

I'd love to know a sure fire way of cleanly, safely removing it though. I'm not sure what type of paint it is though - may have to experiment with a flat screwdriver and see how tough it is.

- trying to think of a way of getting it to mean 'upside down approved' but can't think of one :P