Hi everyone,

 

I have purchased an accident damaged Octavia vR3 mk3. The car has some front and side damage, not too severe but enough to warrent a front frame/apron measurement check to ensure nothign is out of whack. Ive been sifting though the web and have come up a little short. So I have the measurements as per below, but

 

 

what I don't have is the image showing the points between where these measurements need to be taken. (see below). Am hoping someone on this form might be able to upload this. Would be greatly appreciated.

 

 

Cheers

Dariusz

Anyone?

Might be worth paying for an hours subscription to https://erwin.skoda-auto.cz/erwin/showHome.do to get the factory documentation?

I have the entire PDF if you want it but the images are still the same as the ones you posted :(

I have checked my info / pdf's (taken from erWin) and again its shows the same images as you. Obviously a very elusive image. Sorry about that.

Apologies for the delay in response, has been a very very busy last few days.

 

Looked at that and am definitely prepared the spend the money to get the docs, as it's definitely worth it. I was not entirely certain though the downloaded docs would differ from the ones provided in the 'public internet' domain. Thank you to @gon and @Extreme3d for confirming the measurements are indeed missing from their docs too, saving me a few quid.

 

Will work with panel beater I have to perform the checks needed to confirm the frame is straight. They have their tricks of the trade. All in all unless we have a Skoda service tech here whom potentially has access to this info there is little hope this will be freely available thus the the thread can be closed.