Hi!

I have just invested in a Kodiaq 2020 VRS model. I have programmed so that I can lock the car with the remote control when the engine is on. But can't manage to lock it via the door handle. I had a Supber 2019 and I managed to program all that on it. Have tried the same programming on the Kodiaq. But can't even lock the car by the kessy handle when the engine is on. Has anyone done this on the same model? I have read up and down on various forums and tried different recipes. also used google. I have also tried searching this forum and read many posts, but can't find an answer to my problem.
Have activated the following so far:
 09 Cent electronics: ENG141651-ENG115754 -- ZV allgemein - Funk bei Klemme 15 ein.

Found this but it doesn't seem to work Enable passive lock/unlock via door handle sensors (KESSY) with ignition on
B7 - Access Start System Interface
 Long Coding
 0F20000723
 -> 1F20000723
or-> Terminal 15 characteristics of passive entry exit function
 orig. value: Function only allowed for terminal 15 off
 new value: Function only allowed for terminal 15 on 
I have done this via Long code on the 05 ACC/Start authorety system

I have just invested in a Kodiaq 2020 VRS model. I have programmed so that I can lock the car with the remote control when the engine is on. But can't manage to lock it via the door handle. I had a Supber 2019 and I managed to program all that on it. Have tried the same programming on the Kodiaq. But can't even lock the car by the kessy handle when the engine is on. Has anyone done this on the same model? I have read up and down on various forums and tried different recipes. also used google. I have also tried searching this forum and read many posts, but can't find an answer to my problem

I have activated also locking via remote. Never heard of doing it via Kessy on Kodiaq.

On 24/09/2024 at 17:48, linni said:

I have activated also locking via remote. Never heard of doing it via Kessy on Kodiaq.

Ooh 😛 hmm then I'll have to do some more research on this. It would have been nice to have that function on the Kodiaq too

Could be possible, just never heard of.

 

I used this method:

 

Lock doors with engine running
Select Control unit 9 (Central Electrics)
Authorization: 31347
Adaptation
ZV allgemein
Select: Funk bei Klemme 15 ein
Value: Active

What is the current setting for A5 front sensor Long coding Byte 0 Bit 4 Terminal 15 characteristics of passive entry exit function

9 hours ago, ZacDaMan72 said:

What is the current setting for A5 front sensor Long coding Byte 0 Bit 4 Terminal 15 characteristics of passive entry exit function

It is set to "active". see picture of long coding