Hi. I'm having trouble with mounting the brackets in my combi essence drive. I've heard that it's compatible, as long as you make a few holes in the fabric of the boot. It fits almost perfectly, but there is something blocking the part, like 2 milimeters from the place. These are the parts that I'm using, if you have any instructions for this retrofit - please help!

I'm attaching a photo, I made these 3 matching holes in the fabric, but there is still something wrong about the fit.

5E7864512  9B9

5E7864511  9B9
5E7861411  WR9

@SteveTheElder Hi Steve. I've noticed your comments, could you please tell me, whether there is anything that I'm missing here? I would normally use PM, but I think that it might also help the others.

Edited yesterday at 14:571 day by blazko

2 hours ago, blazko said:

Hi. I'm having trouble with mounting the brackets in my combi essence drive. I've heard that it's compatible, as long as you make a few holes in the fabric of the boot. It fits almost perfectly, but there is something blocking the part, like 2 milimeters from the place. These are the parts that I'm using, if you have any instructions for this retrofit - please help!

I'm attaching a photo, I made these 3 matching holes in the fabric, but there is still something wrong about the fit.

5E7864512  9B9

5E7864511  9B9
5E7861411  WR9

@SteveTheElder Hi Steve. I've noticed your comments, could you please tell me, whether there is anything that I'm missing here? I would normally use PM, but I think that it might also help the others.

Do you have a photo of where the problem 2mm is or what you think is causing it?

I can look in my car tomorrow.

The attached are how the side supports look in my car (these were factory fitted), hopefully helps a bit.