P34RC3

I will wait for rami to reply. If he doesn't it yours

I'm in Leicestershire. They are both in good condition. Rockercover just needs a clean up.

Bump

Was toying with painting the bumpstrips when I first got it. Seen a couple of cars it looks good on but others it didn't suit. I'd love pops and bangs. Miss that from my focus St lol.

Going into gears. Reverse I have a bad time trying to pull out of.

My selection is still sloppy after changing the adjusters on the cables on top of the box. Could mine be down to the bush inside the car? My car has done 145k

My selection is still sloppy after changing the adjusters on the cables on top of the box. Could mine be down to the bush inside the car? My car has done 145k

Is there anything else worth changing while I'm there?

Yeh it's a must do really. Get yourself a catch can too. Had shark map out my secondary air pump and charcoal canister. Forgot the two under the inlet manifold but going to wait for a decat then get the lot mapped out.

Did u wrap the rear diffuser?

Keeping the car now... Flew through mot with no advisorys.

I have noticed my mpg has dropped by about 5 mpg. Can't even achieve 35mpg on a run now. Used to get 41mpg on the same route.

I took it up to some fair speed in 5th and it just pulls now. as for the idle I'm not sure. Iv got a tuning company near me that specialises in mitsubishi cars, just dropped him a msg and he will smoke test my car for £30 so going to do that. Orderd up new inlet manifold gasket and injector seats over the weekend. Might get my manifold powdercoated and stick it on.

Surging is now sorted. Had a mixture of stage one and stage two to get it to run right. He did say my idle was normal but it wasn't shaking when it was there. Typical lol.

I'm sat in here now. Apparently they have a map made ready to try so hopefully it will sort it. Also going to have a smoke test done on it while I'm here. Fingers crossed it will get sorted.

Sold

What company's did you use before your custom map?

Bump

Bump

I'll have to check but they look solid in the picture I took.

Tried my mates n75 valve and still got rough idle but didn't get high enough speed to check I'd it still was surging but I'm guessing it would of as it felt no different.

Sweet cheers. Hopefully get it done tomorrow

Nice cheers for that. What do the bolts have to be torqued to? Or is it just ft?

Going to tackle my front arb over the weekend. Below is a picture of the parts I got. Is that all I need? Also what's actually involved? Iv got a pit so hoping that will make it a easier job.