ihinhk

Am sure I read the 1st service is 30000 kms or 3 yrs.

Had the same issue on my 2014 Superb. Took it to a windscreen company they wanted to replace the panoramic roof £900 !!! I just cleared the drain channels with a bit of covered wire. Be careful though, the channel outlet is connected by a rubber hose to the bodywork at the bottom via the A frame. Don't use anything sharp.

I have a Nextbase 622GW front and rear which I had on 3 other vehicles and no problems with any of those but the lates on my 2025 Superb L&K I cannot get the GPS and Speed stamps on recordings. It was professionally fitted by RS Connect via Nextbase. Been in touch with Nextbase and they say it may be an interference with the de-icer built into the windscreen I cannot see any wires in the screen (unlike the other 3 vehicles). I think Nextbase are bull****ting me to be honest. So, on that basis, I cannot recommend Nextbase any longer. If you had asked me 6 months ago I would have said Nextbase. Anyone else had similar issues ?

Has anyone had an issue with their intermittent wipe not working on the windscreen. If I turn on the IW, it will wipe once and then that is it. All four positions on the wiper stalk are the same. From what I have read it could be a relay, the windscreen sensor or something else. Any advice much appreciated. If I take it to the Skoda dealer, then it's going to be £100 before you know it.

I got the letter yesterday from Skoda and I did have the emissions fix done as soon as it was notified years ago. I don't mind having the indicator fix done if it would only take an hour trouble is from my experience Skoda workshops rarely if at all meet the timescales they say and once they have your car you are knackered. Might call my local garage that does all the servicing of my Superb and see if he has access to the fix as he uses a device to check all the electronics when it is serviced and can remap it if you want that too (I didn't).

Yeah I did that to put it in repeat mode in the first place but can't get it out of repeat mode now.

I am using MDI in the centre arm console which allows you to plug in a USB stick. Have used the repeat function previously and never had a problem until recently.

Audio part of media on the Columbus RN510 system is stuck on repeat and I cannot figure out a way to remove the repeat function so stuck with the same song over and over playing from a USB stick. I did select repeat but can't seem to work out how to get out of it. Any suggestions/solutions/ideas ?