TriumphTR6

Thanks Dave for the wire info. Concentrating on the orange black / brown Difficult tell if it’s black or brown I wiggled those in the quad connection and then tracked the twisted wires back into the dash and found a swagged junction with more orange wires and on the other side a red and black. The great news is everything is now working as it should Cheers Simon

Hi both Thank you for info I recall there being an orange and black twisted cable. Might that be it? Thanks

Thanks Dave I should have guessed that ref canBus rather than dedicated ignition source. I have checked the plug on the back and all the wires look to be engaged. Do you know which wire is the canbus feed. I can then concentrate on that wire or that plug in the larger quad lock Thanks Simon

Hi all. After removing the info centre to diagnose a noisy heater flap the system does not seem to recognise I have the ignition on with or without engine running. The left hand buttons on the steering wheel do not work. The head unit screen comes alive if I switch it on but then it does not switch off when ignition is turned off. The radio works and I can navigate the meus on the screen but if I select anything it states "This function is only available with ignition on". Tried soft reset and disconnected the battery but still the same. Its almost as though it does not "see" the ignition power. Checked the only 2 fuses which manual states are info centre. Disconnected / reconnected plugs on the back and still the same. Any guidance would be greatly appreciated Thanks Simon

Carbon vinyl wrap gets my vote for under £10 which would look smart on WA66 ZFX and some left to wrap the mirrors?

Hi Please send me to a previous thread if it can be answered there? I have installed a PF Jones towbar with their dedicated wiring kit. I have connected bike rack to the car and all the lights on the rack and in the car seem to work as should. The only VCDS coding I have done is to add the trailer by ticking 69. Since connecting the electrics into the car I get an ACC error which is there with or without the tow bar connected. If I disconnect the towbar loom half way down the car the ACC error disappears and the car functions as before. Unfortunately in this state the tow bar connection does not work. Spoke to PF Jones who advise the wiring appears to be ok and the car needs other modules coding but they do not use VCDS so could not advise. My current VAGCOM cable which worked on my 2015 plate VRS seems unable to access all the control modules so I have ordered a later 19.6.2 VAGCOM. In anticipation of it arriving can anyone offer advice on which other VCDS coding is required? Many thanks Simon