Skip to content

timmio87

Finding my way
  • Joined

  • Last visited

Everything posted by timmio87

  1. There is a big electrical connector on the steering rack / module right on the subframe, if water gets in this it can cause can bus communication issues which causes various other issues with bits also on the same canbus network. I didn't have my under tray fitted and went through a very deep puddle and couple of miles later the dashboard went mad with all sorts of issues, speedo going beserk and whole host of faults when I plugged in the fault code reader. After a few days of drying out all of the issues went away. I did try to get the power steering connector off to apply some grease to give it a better seal but its really difficult to do so on axle stands and really needs to be on a lift or you need to drop the subframe. Instead I sprayed the connector with some holts damp start which gives a bit of a lacquer seal to electrical connectors and have refitted the under tray and not had any issues since then. My power steering was going heavy and light by the way when the issue occured.
  2. Thanks for that info, I'll run in some extra cables in mine when I get change. What video cable did you end up using for the install? Was it the one supplied with camera or did you buy a shielded one? Also how about the power and ground cables, what type and rating did you use?
  3. Do you still get no interference when the headlights are on and the engine is running? I get some faint lines on the screen when I do this on mine using a similar setup to you although I have earthed to the rear wiper motor body. I have no inference when the engine is running and the headlights are off though. Also when using the rear wiper I get interference on the camera too, engine on and off. Was wondering if this was to do with earthing on wiper motor body or if it was airborne noise being picked up due to the proximity of the camera and motor. If you could let me know that would be great before I got to the effort of running a dedicated earth to the camera.
  4. I tried hooking up a camera, that part works ok but still don’t get the parking sensor display. Not sure if it’s my head unit or something to do with the car module versions. Mines a 58, so last of pre FL so would have thought it’s ok. Do you know what gateway version yours was? Anyone else have experience of this?
  5. Hello, I've installed an Erisin Android head unit on my Pre FL Octavia a couple of days ago and have a couple questions about the CANBUS integration. The head unit i bought is linked below https://www.erisin.com/products/erisin-es8715v-8quot-dsp-android-100-car-radio-carplay-amp-auto-gps-4g-dab-wifi-for-vw-seat-skoda With the CANBUS integration I don’t get any climate info or PDC info on the screen, although the unit detects the car is in reverse, volume drops and the sensor sounder works. With the factory unit (Stream MP3) I got two little distance graphs from the rear of the car when the PDC was activated, I also had key info from the climate flash up when being used i.e front demister on etc. Has anyone had any experience with the pre FL cars using android units, I've seen a lot of info about the FL versions which seem to integrate everything fine. I did quite a bit of reading yesterday which suggested the PDC graph may appear if I hook up a rear camera or maybe if I used a Polar FIS to emulate the display but not sure if this only works for original VW head units? Thanks

Account

Navigation

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.