Gyenes

Thanks man, camshaft fault code gone now But now i replaced the crankshaft sensor. And now the car wont start.. its a brand new sensor. There is difference between the 1.8t arx, bam, auq crankshaft sensor. I dont know why is not working..

Wiring okay i think. The yellow/balck wire is the negative wire and the other(green maybe?) Is the + or no?

Fuel pump working, replaced the pump and the same problem But my biggest problem is what is the Camshaft Timing Adjustment fault code.. 😕

Some hungarian guys says the stock pressure is 0.7, so i dont know. But its not an immo issue, because i turned off the immo And not every time 2 sec, some times 3-4

Hey guys! I have some problem with my project.. I tested my Fabia with auq 1.8t, and everything seemed okay. But i noticed, the turbo gauge says its boosting with 1.3 bar. So i turn back to go home, but after i stop, the car stalls. Started the car, and only 3 cylinder working out of three.. I have new bosch tfsi coils and ngk pfr7s(same to pfr7q i think) plugs. The overboost problem was caused by a missing earth from the n75(maybe), but now i got a Camshaft Timing Adjustment -Short to Ground fault code.. And the car starts only for 2 sec. Anybody can help me? I'm really sad, because i can't use my car about half a year..

Hello guys! I have a little problem with my Fabia. I tried to start the engine, cranks, but wont start. I measured the injectors, and i have 3.12v each injectors and no spark..fuel pump working perfectly, fuel in the hoses, but low the voltage, and i can't figure out why. Somebody can help me a bit? 😞

And one more question, i can make the car alive with the octavia engine loom with the fabia interior loom?

Hey guys, i have a problem, anybody know a solution? https://ibb.co/NNzhy9J

Hmm, okay thanks!!!!!

Hey guys! I was thinking about the secondary air pump, i have to use it? Because for the 1.4 mpi i have to buy a 3 bar air filter, and the filter have 3 tubes..so i have to modify the fuel line?

I hope you will make this swap, and bring a lot of pictures😎

Yea, with a ibiza swap is easier to do, or not?😁

Yes, sorry but im a little bit tired. Thanks for help guys!!!!❤

Yes, i will buy the bigger brakes, next week delivers by the courier, feom a mk1 vrs fabia. This is 288mm the seller said. And i replaced the back bridge, so i have disc brake instead of drum brakes. So the 1.9 shafts fits good? Because i can buy 1.9 shafts fromt the guy who sold the engine.

I have ecu and wiring loom from the octavia, but i don't really know what i have to use in my car. Becausw i have some relays too, but in my car i have relays, for the petrol pump, and idk.