Fabia 1.4 immobiliser problem

Followers

21 February, 200917 yr

My Fabia is starting but then shutting itself off almost immediately. The immobiliser warning light is flashing. According to the manual this can be sorted by entering an "emergency code" from the keyfob, but as I didn't buy it new I don't have this keyfob.

The engine management light had been lit on and off for a couple of days before this - not sure if the 2 are linked?

Can anyone give me some advice on how to sort this please?

Create an account or sign in to comment

Followers

Go to topic listing

No registered users viewing this page.

Announcements

About BRISKODA

BRISKODA is for the sharing of information on ŠKODA. Founded for all motoring enthusiasts, it's free to join and use. We have members from all over the world.

Our Guidelines.
Search the Site.
Explore the Forums.
Gaze into the Gallery.
Make a date, the Calendar.
Classic, custom or modified car insurance!
Please be respectful when posting.

See all Subscription Plans

1.2 TSI loss of power
Skoda Octavia Mk2 (2004 - 2013)

1.2 TSI loss of power

Papez · 1 hour ago1 hr

Hi, hopefully you won't mind my question here - I don't have an Octavia, but its close relative from a Spanish brand. But mechanically, they are same. Anyway, I have a 77kW CBZB. It worked flawlessly for the year I own the car, but when this summer started, I noticed occasional loss of power. It only happens in hot weather (around 30 degrees and up) with AC on. In most cases, it happened when I wanted to accelerate after mild climbing at lower gear at ~2000RPM. It feels almost like a limp mode
- 2 replies
- 14 views
Papez

1 hour ago1 hr

Papez

1 minute ago1 min
Retrofite Blind Spot...
Skoda Kodiaq MK1 (2017-2023)

Retrofite Blind Spot...

Cairus · 3 February3 Feb

So, Today we started installing and wiring the radar sensors. Since it's the facelift rear end, we installed the OEM bracket for the 2Q0 radar sensors. At the same time, we installed the tow hitch. The mechanical part is mostly finished; the cables are in the trunk and all that's left is to route and connect everything inside the car. Coding is also required, of course. A few photos.
- 18 replies
- 835 views
Cairus

3 February3 Feb

Cairus

2 minutes ago2 min
What have you done to your Superb III today?
Skoda Superb Mk3 (2015 - 2023)

What have you done to your Superb III today?

boydeee · 25 August, 20187 yr

There was a similar thread on the Golf GTI site I used to be on and I found it really interesting to see what other's had been up to. My car is due to be built this week (34) so I am counting down the days until I finally get it! So what have you lot been up to?
- 5,357 replies
- 628,253 views
boydeee

25 August, 20187 yr

GREEBO_22

29 minutes ago29 min
Lost 29-Byte ABS Long Coding — 2014 Škoda Octavia 1.8 TSI
Skoda Octavia Mk3 (2013 - 2020)

Lost 29-Byte ABS Long Coding — 2014 Škoda Octavia 1.8 TSI

Salmannn · 41 minutes ago41 min

Hello, I accidentally ran a master initialization adaptation reset inside my ABS module using OBDeleven, and it completely cleared out my long coding profile. My module is now showing a persistent 'Control module not coded' fault. My diagnostic device identifies the blank block template as a 29-byte structure. Could someone with access to an MQB MK100 offline software calculator help me generate my matching configuration code? Here is my hardware and chassis data: Vehicle: 2014 Škoda Octavia Mk3
- 0 replies
- 21 views
Salmannn

41 minutes ago41 min

Salmannn

41 minutes ago41 min
Can't open driver's window without holding onto button
Skoda Octavia Mk3 (2013 - 2020)

Can't open driver's window without holding onto button

Murmansk · 15 May, 20251 yr

65 Reg Octavia estate All my other windows work ok but on the driver's door window I have to hold down the button until the window is fully open. A quick press of the button closes it just fine but opening is the problem. There's no info in the manual that helps I can't help thinking I've had this problem before and somehow solved the problem but I can't remember how. My online research suggested holding the button down until it opened fully and continue holding for a few seconds, then closi
- 10 replies
- 782 views
Murmansk

15 May, 20251 yr

Niro

1 hour ago1 hr

Fabia 1.4 immobiliser problem

Featured Replies

Create an account or sign in to comment

Recently Browsing 0

About BRISKODA

Available Subscriptions

FREEDOM Lite

FREEDOM

Recent Topics

1.2 TSI loss of power

Retrofite Blind Spot...

What have you done to your Superb III today?

Lost 29-Byte ABS Long Coding — 2014 Škoda Octavia 1.8 TSI

Can't open driver's window without holding onto button

Important Information

Account

Navigation

Configure browser push notifications

Chrome (Android)

Chrome (Desktop)

Safari (iOS 16.4+)

Safari (macOS)

Edge (Android)

Edge (Desktop)

Firefox (Android)

Firefox (Desktop)