Anything specific I should aim for when doing up the nuts on the RARB, or just as tight as possible?

Tight as possible

Tight as possible

Forced to take a rain break. Everything went on smoothly....just need a few more rounds tightening all the nuts. I can't imagine those U-bends ever fitting flush to the axle....there will always be a gap between the apex of the curve and the topside of the axle. So far have about 4 cm of the thread sticking out of the nuts for the u-bends....will keep going.

Torque setting = FT

Have only done a quick local drive around and am not being hurled across the car at mini roundabouts. Longer drive to work tomorrow...will give it a proper thrashing!