Has anyone got a piccy of the underside tray on the Octy vRS that I could see? That is the one under the engine!!!

I went over a level crossing today - which wasn't so level and even at 20mph there was an almighty thud :eek: Looking underneath it looks like some of the under tray is hanging down - but it doesn't look like there is anything for it to attach to. So either it is meant to be like that (fingers crossed) or part of the guard has gone.

I will try and get a piccy of mine tomorrow as that is probably better than my ramblings above

:bump:

:bump:

These any good (appologies for the dirt - i would have cleaned it first but I've got a bad head cold today!!)

These any good (appologies for the dirt - i would have cleaned it first but I've got a bad head cold today!!)

Thanks so much for those. I'm just about to go and check and photo my car...will report back soon

Thanks so much for those. I'm just about to go and check and photo my car...will report back soon

If I've understood your post correctly I think you'll be ok. Mine looks as if the back bit is hanging free also.

If I've understood your post correctly I think you'll be ok. Mine looks as if the back bit is hanging free also.

I've put some piccies in my gallery as I can't work out how to attach them in the post

Just comparing it to your car it looks like yours has a bolt holding it up in the middle whereas mine seems to be missing...

I've put some piccies in my gallery as I can't work out how to attach them in the post

Just comparing it to your car it looks like yours has a bolt holding it up in the middle whereas mine seems to be missing...

Just had another look at mine. There's a torx screw at either end but no fixings in the middle - there's 2 empty holes and a protursion (sp? - ie raised bit) approx in the middle.

By your pictures i reckon that yours is the same as mine

Just had another look at mine. There's a torx screw at either end but no fixings in the middle - there's 2 empty holes and a protursion (sp? - ie raised bit) approx in the middle.

By your pictures i reckon that yours is the same as mine

Sounds like I'm ok then! Had a good crawl around underneath earlier and there doesn't appear to be anything for the middle hole and protrusion bit to locate to... so unless something was ripped off it must just be like you describe above!!!

Thanks once again for looking - it is much appreciated