How wide are you wheels?

At the moment im running 16" 6J wheels and dont seem wide enough

Just got some 7J fronts and 9J rear, is or has anyone running something like this and if so, any problems?

Thanks will

Not all about the width, few are running 9s but its the width and et combination that can cause problems.

I'm running 8,5x17" ET30 and they fit perfectly!

Wow thats super smart!

I run 8J superleggeras and its wide as I would want to comfortably go on 205/40 wheels.

im running 10"s ( regardless of what one will say one here) there 10" rears and 9" fronts but i dunno what offest they are but with rolled arches and 30mm spacers they sit perfect

Thought they were 11"

I've got 20mm adaptors on the front and this sit nice but 9j on the rear with adaptors stick out like 60mml lol

Guessing needing the arches rolled?

Sent from my iPhone using Tapatalk

Like so. At the moment it's sitting on the arch.

Sent from my iPhone using Tapatalk

Looking abit "padiflush" atm lol

Im going for hella flush! Im abit padi the moment.

Haha how do you do camber too the rear?

Sent from my iPhone using Tapatalk

Camber shims. I just I boughy some off ebay.

Haha how do you do camber too the rear?

Sent from my iPhone using Tapatalk

Camber shims m8

Fitting guide

http://www.briskoda.net/forums/topic/90281-diy-pic-guide-proper-re-alignment-of-rear-axle/

But with yours u will need your arches rolling + pulling..

Like so...

Yeah hopefully getting done today/tomorrow.

And apparently those shims are crap according to a mate who ran them :/?

Sent from my iPhone using Tapatalk

Yeah hopefully getting done today/tomorrow.

And apparently those shims are crap according to a mate who ran them :/?

Sent from my iPhone using Tapatalk

Crap... because....??

No idea. He said his snapped and stuff. Ill ask him

Sent from my iPhone using Tapatalk

Im guessing they snapped when he was fitting them?.. there made of plastic because they dont take any strain etc..so if fitted correctly they shouldnt snap lol..

Think you will need huge arch pulling (meaning a paint job on rear qaurters) and camber to get those to fit. What et are they because that is huge poke!

Also the camber shims i doubt a company like eibach would sell crap really.

I know its mental dont really understand the ET lol?

But i think there ET45/50?