Bolero+MDI Scan required

[robcrac]

Hi to all,

I've a 2012 Yeti with MDI retrofitted by Skoda service and then with 2012 Bolero retrofitted by myself. All is working but when I bought VCDS, after first scan, I founded two errors in MDI and Bolero:

 

Address 2E: Media Player 3 (J650)       Labels: 5N0-035-342.lbl

   Part No SW: 5N0 035 342 C    HW: 5N0 035 342 C

   Component: SG EXT.PLAYER H13 0111  

   Revision: A1001003    Serial number: 7668152602    

   Coding: 010000

   Shop #: WSC 00000 000 00000

   VCID: 275D1D175618CF26F59-8072

 

1 Fault Found:

03138 - Input AUX IN 

            009 - Open or Short to Ground

             Freeze Frame:

                    Fault Status: 01101001

                    Fault Priority: 4

                    Fault Frequency: 1

                    Reset counter: 56

                    Mileage: 66603 km

                    Time Indication: 0

                    Date: 2031.14.24

                    Time: 19:03:59

 

Address 56: Radio (J503)       Labels: 5M0-035-1xx-56.clb

   Part No SW: 1Z0 035 156 M    HW: 1Z0 035 156 M

   Component: BOLERO        001 0008  

   Revision: -----08S    Serial number: SKZ4Z3M1150970

   Coding: 0D0200000000

   Shop #: WSC 73430 790 00095

   VCID: 3C77D27BBF9E7CFE88B-8069

 

1 Fault Found:

01044 - Control Module Incorrectly Coded 

            000 - -

             Freeze Frame:

                    Fault Status: 01100000

                    Fault Priority: 5

                    Fault Frequency: 27

                    Reset counter: 56

                    Mileage: 0 km

                    Time Indication: 0

 

             Freeze Frame:

                    Bin. Bits:      100

 

After searching in forums, I found then someone had a little bit of problems to retrofit MDI on a Bolero (or RCD510), due to Aux incompatibility with Bolero.

 

I don't find a solution yet.

 

So, I kindly ask to the owners of Yeti preFL or Octavia II FL with Bolero&MDI (without Bluetooth&Sound System) a scan in order to check correct coding for both.

 

Thank you in advance

[adamal]

I get the first if I have a lead plugged into the aux with no device attached. It doesn't come back immediately if I clear it so I figure its not an issue. Have you tried clearing it? Admittedly I have a Columbus but I imagine it would be similar for you.

For the second just work through module 56 and check each byte carefully in the long coding helper.

[robcrac]

thank you for the answer. Yes, I've tried to clear both. I'll check option regarding Bolero soon

[adamal]

I assume the aux in works when you attach a source?

[robcrac]

I never tried it,I don't have a cable

[robcrac]

I never tried it,I don't have a cable

[adamal]

Probably worth grabbing a cheap 3.5mm jack cable and seeing if you can play music off your phone or mp3 player or similar to rule out any actual problem.