Regarding the price. The cost of 3M 1080-G212 should be $35-50 per meter. Combi roof and trunk spoiler required 2.3 meters. Work is worth $40

Отправлено с моего iPhone используя Tapatalk

Tomorrow I plan to wrup my roof with 3M Scotchprint 1080-G212:

Tomorrow will be an additional photo.

Now my car looks like this:

Отправлено с моего iPhone используя Tapatalk

That should look awesome.

 

Not sure about the wrapped roof box though (unless your going for the stealth look)!

I have new photo:

Отправлено с моего iPhone используя Tapatalk

Supplier did not have 3М film, so the installer to use Arlon CWC-226 Black Metallic:

Отправлено с моего iPhone используя Tapatalk

Edited 21 March, 201511 yr by nightSHIFT

That looks really sharp nightSHIFT - did you remove the roof rails and is so was it difficult?

That looks very good top job there

It is quite difficult:

8.2 Removing and installing the moulded headliner (Octavia III - Combi)

Removing:

– Switch off the ignition and all electrical components.

– Removing sun visors ⇒ page 279 .

– Remove the top trim panel of the pillar A ⇒ page 365 .

– Loosen the top trim panel of pillar B ⇒ page 368 .

– Remove the trim panels of pillar C ⇒ page 373 .

– Remove the D pillar trim panels ⇒ page 379 .

– Remove the recessed handles of the roof ⇒ page 281 .

– Removing rear seat bench ⇒ page 412 .

– Remove seat backrests ⇒ page 415 .

– Fold the front seat rests towards the rear.

– Put the steering wheel into the lowest position by means of the adjustment functions.

Vehicles with interior monitoring– Disconnect the motion sensor and the sensor for vehicle in‐ clination (depending upon vehicle equipment) ⇒ Electrical System; Rep. gr. 96 .

All vehicles– Remove the inner light front and rear ⇒ Electrical system; Rep. gr. 96 .

– Unclip the storage in the roof.

– Release screws for the storage frame (1.5 Nm).

– Unclip the storage frame.

– Loosen the moulded headliner - 2 - rear and undo the clip - 1 -.

– Loosen the moulded headliner -2- out of the door seals.

– Lower the moulded headliner - 2 - together with a 2nd me‐ chanic (risk of fracture).

– With a 2nd mechanic, remove the moulded headliner through the tailgate opening.Installing:

– Installation is carried out in the reverse order.NoteBefore the installation, check all the fixing elements for damage, if necessary replace.

– Ensure that the moulded headliner is located in the double- braided strip of all the door seals after the installation.

Manual:

- Body Work: http://dfiles.ru/files/uo0y8g0ah

Отправлено с моего iPad используя Tapatalk

Edited 21 March, 201511 yr by nightSHIFT

Looks great

Anyone had this done recently? Considering it for my white mk3.5