I started my car last night everythink was fine, I reversed back and when into 1st and stalled the car, on rear start it struggled to start.

I drive off the glow plug light was flashing and no boost, I hoped wen I woke up this morning the problems had gone but they are still here, plug in a code reader and it's came bk with

P0727 engine speed input circuit no signal

P2102 throttle actuator control motor circuit low

P0243 turbo wastewater solenoid a

P0489 exhaust gas recirculation control circuit a low

I'm guess this is an electrical problem I have checked fuses but all seem ok, I've tried a search but came back with nothink, can sum 1 help

Stalling a car at low speed can stress the wiring loom as the engine tries to jump out of the engine bay.

Stalling a car at low speed can stress the wiring loom as the engine tries to jump out of the engine bay.

 

rubbish

I started my car last night everythink was fine, I reversed back and when into 1st and stalled the car, on rear start it struggled to start.

I drive off the glow plug light was flashing and no boost, I hoped wen I woke up this morning the problems had gone but they are still here, plug in a code reader and it's came bk with

P0727 engine speed input circuit no signal

P2102 throttle actuator control motor circuit low

P0243 turbo wastewater solenoid a

P0489 exhaust gas recirculation control circuit a low

I'm guess this is an electrical problem I have checked fuses but all seem ok, I've tried a search but came back with nothink, can sum 1 help

 

try resetting fault codes (write them down first) if they come back google them

rubbish

 

Ok, don't bother checking the wiring, this guy knows better. 

I've cleared the fault codes but come back, I do believe it is wiring related, I have had a quick look at the wiring but seems a lot of play in it and nowhere where it's tight, going to strip it down tomorrow to do a check all the wires, I think it's lost a 12v feed sum where

Also I got no brake lights, tried changing the brake peddle switch it's still the same

Checked ur bulbs?

Stalling a car at low speed can stress the wiring loom as the engine tries to jump out of the engine bay.

 

Ha ha ha ha ha

 

All time classic!

 

For seemingly a well read individual, sometimes a little gem emerges.

 

Could be a earth wire has pulled away,or just got a bad connection/corrosion on the joint.

That's a lot of faults on different parts of the engine,speed sensor is down the front below oil filter,EGR is on the rear of engine.

Might be worth checking the ECU multi plug is ok,get some electrical contact cleaner ready for when you check connections.