hi all, i have a set of decent wheels from my old vectra that i still have, being vxr replica's

 

i have read online that the sizes are 5x110, offset 35-45 and a centre bore of 65.1

 

 

current wheels on my octavia are pretty hard done into and i've always likes my vxr wheels, polished with black edges, is it possible to fit these?

Pcd and centre bore are wrong - both too small. You could presumably make them fit with adaptors.

Sent from my D5803 using Tapatalk

Pcd and centre bore are wrong - both too small. You could presumably make them fit with adaptors.

Sent from my D5803 using Tapatalk

 

ah yes sorry i should mention i know it is the wrong size but to what extent do i need to go to make them fit

Wobble bolts might work but you need to get the centres machined out to the right bore.

Or adaptors if you can buy them off the shelf with appropriate bolts.

Sent from my D5803 using Tapatalk

What diameter and,width are the wheels?

Sent from my D5803 using Tapatalk

could you use enlarged spigot rings and wobble bolts?

Wobble bolts might work but you need to get the centres machined out to the right bore.

Or adaptors if you can buy them off the shelf with appropriate bolts.

Sent from my D5803 using Tapatalk

Centre bore is already bigger so just need a spigot ring.

Centre bore is already bigger so just need a spigot ring.

Duh, my brain hurts.

Sent from my D5803 using Tapatalk

that's very relieving then spigots are only cheap, what are people's take on wobble bolts? safe?

these are the wheels in question by the way, to be going on a black vrs estate

 

Edited 16 July, 20169 yr by lDanl

I've run wobble bolts before with no issues.

that's very relieving then spigots are only cheap, what are people's take on wobble bolts? safe?

 

Ran 5X112 PCD wheels on a Vectra for over 6 years with wobble bolts and spigot rings, no problems what so ever.