Loose wires + Sensor Plugs

[CramVRs]

Hi All

 

it looks as though I have a loose wire within my rail pressure sensor plug.  Is there a way to fix these or maybe replace them?  The wire (i believe) could come out.

 

any helps appreciated.

 

thanks in advance

[CramVRs]

anybody?

[pist0nbr0ke]

I'm guessing this is something that happened/was discovered whilst fitting the DTUK box? If the wire is loose, you can only hope to crimp it back in somehow, or even solder it. I doubt just a connector can be replaced without a whole section of loom.

 

I suppose warranty is out of the question - the dealer will probably want to know why you were anywhere near it 

 

So not very helpful, sorry. Perhaps an auto electrician could sort it?

[CramVRs]

yeah spotted it when the box was fitted.  It would seem that tools can be bought to remove the pins and then reinstall them.  The pins themself are over £3 each and they can be reused once crimped which is a pain.  Auto electrician didnt seem interested to be honest