Finally got my Vag-Com registered and working. First job was to put the anti-hijack feature on. I then turned the alarm chirp on ans the interior monitors. After I was done, I scanned for fault codes and got the following response. Can anyone advise please. The car runs ok, so not sure if they just need clearing???

Address 08: Auto HVAC

01274 - Air Flow Flap Positioning Motor (V71)

37-10 - Faulty - Intermittent

Address 16: Steering wheel

00926 - Terminal 30

07-10 - Signal too Low - Intermittent

Address 17: Instruments

01336 - Data Bus for Comfort System

49-10 - No Communications - Intermittent

Address 19: CAN Gateway

01336 - Data Bus for Comfort System

49-10 - No Communications - Intermittent

Address 36: Seat Mem. Drvr

00668 - Supply Voltage Terminal 30

002 - Lower Limit Exceeded - Intermittent

Address 55: Xenon Range

00532 - Supply Voltage B+

07-10 - Signal too Low - Intermittent

Address 56: Radio

00852 - Loudspeaker(s): Front

36-10 - Open Circuit - Intermittent

00853 - Loudspeaker(s): Rear

36-10 - Open Circuit - Intermittent

cheers

I've just got the free software version from Ross Tech. Am I right in assuming that I need the registered version to alter the xenons, c locking etc? If so where do I get this number from. PM me!

Finally got my Vag-Com registered and working. First job was to put the anti-hijack feature on. I then turned the alarm chirp on ans the interior monitors. After I was done' date=' I scanned for fault codes and got the following response. Can anyone advise please. The car runs ok, so not sure if they just need clearing???

Address 08: Auto HVAC

01274 - Air Flow Flap Positioning Motor (V71)

37-10 - Faulty - Intermittent

Address 16: Steering wheel

00926 - Terminal 30

07-10 - Signal too Low - Intermittent

Address 17: Instruments

01336 - Data Bus for Comfort System

49-10 - No Communications - Intermittent

Address 19: CAN Gateway

01336 - Data Bus for Comfort System

49-10 - No Communications - Intermittent

Address 36: Seat Mem. Drvr

00668 - Supply Voltage Terminal 30

002 - Lower Limit Exceeded - Intermittent

Address 55: Xenon Range

00532 - Supply Voltage B+

07-10 - Signal too Low - Intermittent

Address 56: Radio

00852 - Loudspeaker(s): Front

36-10 - Open Circuit - Intermittent

00853 - Loudspeaker(s): Rear

36-10 - Open Circuit - Intermittent

cheers[/quote']

Hi all, as you have said your car runs fine all the fault codes registered are all sporadic fault codes. First of all id take a print out of the codes clear all faults and monitor systems. Batterys being disconnected or low on capacitie will do this, as you can see there are a few B+ fault codes.

battery did go flat last week and had to be jump started. Hopefully the codes are a result of that.

Address 08: Auto HVAC

01274 - Air Flow Flap Positioning Motor (V71)

37-10 - Faulty - Intermittent

This is a common one which you should find in the search.

Clear the others and see what comes back.

Yup - Its the ones which immediately return following clearance that might need attention, or in my case, not.

It doesn't have scare you though the first time you check and the screen fills up with error codes. :eek:

I've just got the free software version from Ross Tech. Am I right in assuming that I need the registered version to alter the xenons, c locking etc? If so where do I get this number from. PM me!

Differences between shareware and registered versions are here and the bottom of each page in the Online Demo/Manual here. To register/activate your shareware read here.

Differences between shareware and registered versions are here and the bottom of each page in the Online Demo/Manual here. To register/activate your shareware read here[/url'].

It costs $99 to do so.