Skip to content

Superb 1.6tdi 2013 Oil Pressure Sensor Location

Featured Replies

Evening all, I'm looking for help with a oil pressure sensor. 

I know where it is and how to get to  it.

BUT..every socket,spanner ( 24mm ) just doesn't reach it. 

My question was could I remove or move the plate next too it for better access or is the plate attached to something inside?? 

Ps I've had it changed once and the mechanic took around 2 hours and charged £110. 

It still comes up on the dash and I've bought a genuine sensor from Skoda, rather £5.10 from Ebay. 

 

Thank you in advance. 

20220303_201252.jpg

20220303_201204.jpg

20220303_201000.jpg

  • Sponsor

Can you not smash the plastic parts out of the way and then use a 24mm socket on the remains? 

Or a borrow/buy a deep reach socket that will fit over it.

Edited by Pete_Ex-Wino

  • Author

I could do but the gap between the top plate( s ) is very narrow. Ideally want to know if I can remove it. 

I am sure that is the engine lift bracket held on bt 3 bolts one is a triple square..

Or

24mm thin walled deep socket from Amazon

51Xi4QXpVtL._AC_SL1500_.jpg

Edited by DEL80Y

Impact sockets are not usually thin walled, in fact usually the opposite, a box spanner would be though.

 

I would be checking all the wiring connections & cables for integrity before struggling to replace a second sensor.

 

Editted, I agree that removing the bracket would be the best option, I don't think that was in the now editted posting when I read it.

Edited by J.R.

  • Author

Thank you Delboy will try the deep socket. The engine lift bracket sounds risky. 

  • Author

J.R if I do remove the bracket is there risk of damage. Its a engine lift bracket. Stupid question but does it mean the engine is attached to these bolts. 

Thanks in advance 

  • Author

FINALLY !!!! Removed the one single nut on the  housing, which is a triple square but I used a T50 Torx bit. Moved the housing aside and after almost a week I used a 24mm spanner and changed the sensor.

 

Went for a spin round the block and no warning on dash. Will drive to work later and see what happens. Fingers crossed. 

20220305_132739.jpg

20220305_132725.jpg

Create an account or sign in to comment

Recently Browsing 0

  • No registered users viewing this page.

Account

Navigation

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.