Hi friends anyone kindly help me my car showing. Oil sensor work shop but oil is maximum level  Please.

The sensor measures low level... and the temperature of the oil.  You need to scan the car for codes as the sensor might be fine... but have a wiring loom issue.

Thank you so much for your valuable responding

But oil level is full

Just now, GOPALAKRISHNAN said:

But oil level is full

It does not know when it is full, only when it drops down low it sends a message.

If you start the engine, and drive a little you should be able to bring up oil temperate on the screen.. if this is not available, then you have either a broken sensor or the wiring to it is broken (hence the message)

 

I would suspect more than likely a wire is broken as it is low down at bottom of engine and can be damaged easily.  So inspect wiring in that area, or get a code reader scanner that can investigate the fault code(s) stored in the car.

Recently rat damaged some wires

 

2 minutes ago, GOPALAKRISHNAN said:

Recently rat damaged some wires

 

Sorry to hear that, but it is an issue.  So you may need to repair this wiring, or run 2-3 new wires to "bypass" the damaged area.

Recently I reconnected the wires

You will need to determine if it has damaged the wires from the sensor and repair them.

 

If you’re unsure of how, I’d suggest a trip to a independent garage, but others on here may be willing to give more detailed guidance.

Sure

On 19/01/2023 at 09:40, GOPALAKRISHNAN said:

Recently rat damaged some wires

 

For the oil sensor. Look at the oil pan. Its the only sensor there usually. Check for your rat damage. If not there you'll have to trace wires back until you find where... unless it'sjust coincidence and fault is the sensor...

Sure