Yes

So the channels are changed. I have sound. What is difference with TT and HT? Only channel 1/4 TT are active correct?

 

 

I also get two errors

On 18/04/2024 at 10:36, pab567 said:

Yes

I've disabled MOST.
I've got sound, but is sound system external booster correct? Isn't that for OEM? I used external booster and internal, both read 2,2V 

Byte 11 05
long coding 5F (multimedia) -> byte 11 (sound system) -> 05 (sound system external booster)

 

And why choose FF -> 4 channels, 8 speakers. Why not BE -> 4 channels, 6 speakers. As I only use Full frequency front and back. Or does 8 speaker mean full frequency?

In original setup:

8 speakers means front 2 tweeters and 2 woofers, rear 2 tweeters and 2 woofers

6 speakers means front 2 tweeters and 2 woofers, rear 2 wideband

2 minutes ago, pab567 said:

In original setup:

8 speakers means front 2 tweeters and 2 woofers, rear 2 tweeters and 2 woofers

6 speakers means front 2 tweeters and 2 woofers, rear 2 wideband

I choose the 8 speakers and with the parameters enabled 1-4 HT/TT. I get full range signal on FL FR RL RR. But the signal measures 2.2V. But maybe it’s enough

It's enough to drive external aftermarket PA

Hello

I want to do this on my Enyaq , change coding from canton amplifier to internal amp.

How to do it ?

1 minute ago, Lazzie67 said:

Hello

I want to do this on my Enyaq , change coding from canton amplifier to internal amp.

How to do it ?

Don't believe it's possible. Kodiaq was also only possible till I believe 2020. 

What do you think about this ?

 

I know this is an unfashionable opinion, but it is also worth (if your firmware is capable) - of enabling "Skoda Surround" on the MIB system.  This is a coding change only.  See my posting from a while ago, but it has all the options to enable up this feature:

 

 

Hello , i have a canton amplifier and I would like to know if does anyone know where the temperature resistor is located that turns on the fan on the motherboard, my fan does not work and the amplifier heats up