Hi again all I have just changed the turbo on a friends 2018 Skoda octavia vrs and we are getting error P256300. Dose anyone know the factory settings for the waist gate?

Edited 13 February, 20233 yr by mattft86

It's normly set up on the bench. You'll need to post the error descriptor.

 

Edit. Actually I say that for petrol. Is this petrol or diesel. 

Edited 13 February, 20233 yr by TheClient

Have a look at this. Should help.  It is focused on is38 upgrade but setup of voltage and adaption should be same for is20.  Thus is assuming this is a petrol car.

 

https://mygolfmk7.com/2019/08/wastegate-first-adaptation-charge-pressure-actuator-p2563/

 

3 minutes ago, TheClient said:

Have a look at this. Should help.  It is focused on is38 upgrade but setup of voltage and adaption should be same for is20.  Thus is assuming this is a petrol car.

 

https://mygolfmk7.com/2019/08/wastegate-first-adaptation-charge-pressure-actuator-p2563/

 

It is petrol. There’s an adaption? I gather in vcds?

Yes in vcds and should also be one in OBD eleven. I haven't used either but the guide attached shows you how to start with the unconditioned voltage reference and adjust waste gate length from there. Then run adaption. The adaption will not complete if it is too far out.