Do you need to reprogram ABS module if you only replace hydraulic unit

Morning all - I have the task fitting a new ABS module on my 2011 skoda octavia - at first I was looking at the repair kit below but found none about.

Repair kit 1K0 698 517 B  Suitable as a replacement for the hydraulic blocks:

1K0 614 517 B, C, D, E, H, J, M, N, Q, T, AA, AB, AE, AF; 3T0 614 517, 3TO 614 517 A and 2K3 614 517

So I decided to buy a tested full unit exactly the same as what's on my car 1K0 614 517 AB - on my replacement new part can I remove the connector block from the hydraulic block removing the 2 screws in affect  creating a repair kit and just replace the hydraulic block/pump? and does this remove the need for programming? 

I am hoping to get this done this week, the fault is traction control light stays on and diagnostics pointed at ABS module 100%

Any advice would be greatly appreciated 

Thank you