hello fellow members.

 

i am having trouble locating the lambda sensor on my car 2013 1.4 tsi 6 speed rapid, any help would be helpfull

 

thanks 

https://club.autodoc.co.uk/manuals/how-to-change-lambda-sensor-on-skoda-rapid-spaceback-nh1-replacement-guide-29830

 

I have 2 lambda sensors on my Yeti, S1 and S2, before and after the catalyst.

Bank 1 is exhaust manifold run, so only for V engines really.

Edited 13 April, 20242 yr by aubrey

31 minutes ago, Gymbro1976 said:

hello fellow members.

 

i am having trouble locating the lambda sensor on my car 2013 1.4 tsi 6 speed rapid, any help would be helpfull

 

thanks 

sorry 7 speed 

 

thanks, i dont think my car is a spaceback but it chould fit 

@Gymbro1976   I just Googled P0030 it said that is the primary sensor, so I'd say S1 as my VCDS would say.

So it's the engine side of the catalyst. Sometimes they are accessed from above and not underneath. My Yeti S1 Lambda for example is easy change from above, far easier than the S2 underneath.

Don't go changing the wrong one out of the S1 and S2.

Thanks where did you get your vcds from. 

1 hour ago, Gymbro1976 said:

Thanks where did you get your vcds from. 

I brought it years ago, back in 2007 I think. The older HEX-USB+CAN one, but it still does me fine.

I can't remember now who I brought it from now, but it has served me well over many years. Was a few hundred pounds IIRC.

New one order and the socket for it thanks for the help 

Update on o2 sensor just take air filter and etc out lol

Think you could say yep it’s f**ked lol

Hope the mating connector in the loom is OK?

12 minutes ago, Breezy_Pete said:

Hope the mating connector in the loom is OK?

Yep that was all good