Hi,

The bracket by the wheel arch on the near side of my rear bumper was broken and the bumper by the join on the rear quarter panel was protruding significantly, I have replaced it but the bumper is still protruding by a few mm's. Is there a technique to getting the bumper to sit flush with the quarter panel?

I wondered if it's better to start with the bottom screw in the wheel arch liner and work your way up rather than the opposite, which is what I did!

Any tips much appreciated.

On a VRS, which has two rear bumper skins. It's normal for the outer skin to sit proud by a couple of mils.

J.