Hi all, what does...

06-10

...mean after the fault code?

The power steering is working intermittently on my x-reg Fabia and a quick scan with VAG-COM shows:

01288 - Terminal 30: Steering Assist

06-10 - Signal to high - Intermittent

The Ross Tech wiki page says battery voltage too low, but that has 07-10 after the fault code!

Any help would be much appreciated.

Either the battery is at fault. or YAW angle sensor.

does the steering warning light come on when u 1st start the car? if so change the battery. if not go for YAW angle sensor.

Yes the light comes on when ii first put turm the ignition on then stays on when the engine has started.

There is a rather corroded wire at the battery so I have cleaned this up best I can and will get a new one asap. The light hasn't come on again since I cleaned it up, so good sign!

From here VAG-COM: uitleg - tips - trics

Additional Information - Extra code at end of error messages:

01 Signal Shorted to B+

02 Signal Shorted to Ground

03 No Signal

04 Mechanical Malfunction

05 Input Open

06 Signal to High

07 Signal to Low

08 Control Limit Surpassed

09 Adaption Limit Surpassed

10 Adaption Limit not Reached

11 Control Limit not Reached

12 Adaption Limit (Mul) Surpassed

13 Adaption Limit (Mul) not Reached

14 Adaption Limit (Add) Surpassed

15 Adaption Limit (Add) not Reached

16 Signal Outside Specifications

17 Control Difference

18 Upper stop spec

19 Lower stop spec

20 Malfunction in Basic settings

21 Front Pressure Build-up time too long

22 Front Pressure Reducing time too long

23 Rear Pressure Build-up time too long

24 Rear Pressure Reducing time too long

25 Unknown switch condition

26 Output Open

27 Incorrect Signal

28 Short to B+

29 Short to ground

30 Open or Short to B+

31 Open or short to Ground

32 Resistance too High

33 Resistance too Low

34 No Malfunction

35 -

36 Open Circuit

37 Faulty

38 Out won't Switch or Short to B+

39 Out won't Switch or Short to Ground

40 Short to another Output

41 Blocked or no Voltage

42 Speed Deviation too High

43 Closed

44 Short circuit

45 Connector

46 Leaking

47 No Communication or Incorrectly connected

48 Voltage supply

49 No Communications

50 Setting (Early) not reached

51 Setting (Late) not reached

52 Voltage Supply too High

53 Voltage Supply too Low

54 Incorrectly equipped

55 Adaptation not successful

56 In Limp-Home mode

57 Electric circuit failure

58 Can't Lock

59 Can't Unlock

60 Won't Safe

61 Won't De-Safe

62 No or Incorrect Adjustement

63 Temperature Shut-Down

64 Not Currently Testable

65 Unauthorized

66 Not Matched

67 Set-Point not Reached

68 Cylinder 1

69 Cylinder 2

70 Cylinder 3

71 Cylinder 4

72 Cylinder 5

73 Cylinder 6

74 Cylinder 7

75 Cylinder 8

76 Terminal 30 missing

77 Internal Voltage Supply

78 Missing Message

79 Please Check Fault Codes

80 Single Wire

81 Open

That's a very useful list. I have printed off a copy to add to my VAG-COM reference material.