I think you should start to make these for people, will make yourself a bit of cash and

you will be helping people out too, il have one

Only a one bar boost gauge, not going to get it mapped then................?????

Neat job, but awkward to see when ragging the car and looking where your going???

MINTED!!!

thats some custom install.. i want to do one for my own car, but using the drivers side vent as theres no room above the radio like what you have there.

liking the carbon too, well done!

ive put mine there and i think it looks spot on and not as difficult to do as you might think

http://www.briskoda.net/forums/octavia/boost-gauge/82649/

good work though moo:thumbup:

very good tutorial mate

did you use the wires on the headunit to power it?

A fine effort

Steve

did you use the wires on the headunit to power it?

sorry for the late reply iv been a little busy with my time lol trying to fit a boot install for my sub and amp lol as for the question i took the power for the air/fule gauge i put in off the 12v supply from the head unit and i also took the power for the lights off the light switch so when i dim the lights on the interior the lights on the gauge also dim as well :eek:

I must say that does look very good and tidy!

Careful the cow dont get too settled in that whole he wont ever want to leave!

A*

i did have real problems evicting him so i could get the air/fuel ratio gauge in there lol