I'm thinking about buying alloys for the felly, but I'm not sure if these will fit..

Specs:

Diameter 16"

Width 7,5"

ET/Offset 35

Will I have problems with arches or shocks?

You might have clearence issues, but it really needs offering the rim up to the car to check where.

More critically, check the Pitch Circle Diameter of wheel and car!

You mean the stud pattern (felicia: 4 x 100) or the center hole (felicia: 57,1)?

stud pattern is PCD mate.

at 7.5J you may have issues on full lock and with the rears rubbing on the arch.

but it is a trial and error job there. borderline stuff.

is it lowered at all?

stud pattern is PCD mate.

at 7.5J you may have issues on full lock and with the rears rubbing on the arch.

but it is a trial and error job there. borderline stuff.

is it lowered at all?

Thanks for clearing the PCD up, my english is a bit rusty from time to time..

Not lowered, yet, but I'm planning to go a bit lower (max 30mm). I need to make some measurements and check if theyre even street leagal in Finland...

Oh dear, another Briskodian from Finland! Hello, neighbour! :wavey:

there to big my friend.

the widest tire you can use is a 195. on a 7J rim this is stretched. on a 7.5J it would be to stretched.

and 16" is going to mean your over all size will need to be bigger, this will put your speedo out.

the best size to go for is a 15" by 6 or 6.5J rim.

with a 195/45 or a 195/50 tire.

I can live with a speedo error using low profile tires on 16". But I think you're right about 7,5" being too wide, maybe 6,5" or 7"... Sad since the rims in question would have been a bargain...

Swedishskoda: Are there other finnish briskodians besides me? And hi to you also, always nice to see scandinavians!

JSwedishskoda: Are there other finnish briskodians besides me? And hi to you also, always nice to see scandinavians!

Yes, I've met a few here - among the Felicia owners there's SuomiSkoda.fi who is about to mod his car:

BRISKODA - The Skoda Forum and Community

I am also from Scandinavia, from little Denmark.