alecg51

Thank you all very much for your help, I'm very impressed

Thank you all so far, very kind The golf has been on a bit of a journey this year:

Where would I find the aircon pipes (stupid question perhaps but I'm new to the Yeti!). It's a Mk1 Golf, with breathed on mk3 tdi engine and running gear!

Hello, We today have picked up a second hand Yeti from our local main dealer, so far so good, although pulling into the drive on the way home I heard some metal scatter across the road. I got out and found this: Does anyone recognise it? There are no markings or anything? Our drive is off the entrance to the development we live on so it could well be from another car? Anyway, here is the Yeti (my wifes), next to my car...

Update, it's all sorted. Thanks for your help!

I am using aftermarket component speakers. I wired them up as before but to no avail-I was using the adaptors to the cross over then cross over to speaker and tweeter, but there is noise everywhere but there! Ill check with another cross over (only just replaced the drivers side speakers, so passenger side's still boxed!) to rule that out, if no luck I'll borrow a multimeter!

Hello, Is this the case for Octavias mk1s too? Thanks

I changed the loom over (the plug on the lock was a right sod) and bingo I have an led, and locking door on the remote,happy days! However,it has come at the sacrifice of my front drivers side speakers... I'm debating bypassing the loom wiring for the speakers now Really confused!

Thank you, that makes perfect sense - I'll do what you suggested tonight!

That's what I thought. I will take the door card off again later and double check with my existing one - there doesn't appear to be any new connectors or anything from where the grey and blue wire goes from one into two for example. I guess (in an optimistic way) it could be someone's extra protection! Ideally I could find a decent picture of a new/known good loom, but I can't find one anywhere.

It has a fabric wrap over it which seems to be keeping the loom bunched together, however at theose points I mentioned the wires were wrapped in duck/duct tape. I took the duck tape off and had a look. The wires under this tape were stripped and bunched together - it looks quite a neat job, and there are marks from where they look to have been crimped. Not being a "wire man" I'm not sure if this helps? Thank yhou so much so far though!

Thank you. There was an oval cover and it covered two screws. Next question really is has my "new" loom been butchered? Are the brown cables meant to be joined together and wrapped in cable (in the door end of the loom), and the brown and yellow cables towards the car end of the loom? Also, there is a grey and blue wire which splits from one wire into two? I can't find any pictures and forgot to look when I had the door card off last night, doh! Thanks again.

Do you have the drivers side door loom?

Thank you very much, that's tomorrow lunchtime sorted then!

Ok thank you, is this easy to get to? Looking at my "new" loom there are a few brown cables, and further along brown and yellow cables connected together and covered in what seems to be duct tape, is this normal?