Blanco
Members-
Posts
382 -
Joined
-
Last visited
Profile Information
-
Gender
Male
-
Location
Ayrshire
Car Info
-
Model
Fabia Vrs
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
Blanco's Achievements
-
Cheers mate, will look for a tdi one then.
-
so just look for one with the spaced out pulley then? Gonna order from ebay tonight
-
will a 90amp one off a petrol engine do?
-
Thanks guys, ill just buy another alternator. Does it have to be off a vrs or will any fabia 90amp with correct pulley do?
-
Hi guys, as you know ive been having problems with the vrs taking longer to start, limp mode etc. well at the start of the week my alternator starting screeching. I was planning to look at it this weekend but on the way to work this morning i heard it was grinding. I continued on untin i saw my battery light come on & smelled smoke. Pulled onto the hard shoulder & found the alternator pulley had come off & the belt was burning! Removed belt & drove home. What alternator do i need? Looking for a second hand one from scrappy due to needing it for monday. Could this be the cause of my other issues? Cheers, Andy
-
broken wire? Any tips to locate it?
-
Hi guys, fitted a new camshaft position sensor yesterday. Cleared codes using vcds as there was an abs one too?? Went to start the car & problem is still there. Taking 5 seconds to start. Sometimes cuts out/limp mode. Checked with vcds & cam sensor code is back?! Timing looks ok (above) What else could this be? Should i cut my losses and sell as it is for £1k? Cheers yet again guys, Andy
-
Bearing in mind ive not driven it today
-
Checked it out, wasn't labeled torsion value but reading was zero. How do these readings look? Maf etc..http://imgur.com/jdu2WhC
-
can i do this with vcds lite?
-
excellent will order one asap.
-
Hey guys, got an ebay special vcds lead & vcds lite. Scanned for codes & found this instantly http://imgur.com/jrICfii Camshaft position sensor. Would this explain starting & limp mode problems? Cheers
-
Its easy mate, took me half an hour on sunday to do it got the fright of my life when it snapped though. I just drilled out rivets & use self tappers next to the rivet hole when re fitting. Sealed up holes left afterwards
-
Gonna buy a generic vcds lead & get to the bottom of this
-
thAnks for replying bud, ive got one the same as that buddy. Its been throwing up a few different codes but the constant usually is N/A. Just want to get it running perfect & sell it.Once again thanks everyone for helping my out.