Footwell Lights

41 images

• metal casing refitted

• led through the diffuser

• LED fitted

• replacement super white LED

• split apart to show the original halogen

• diffuser

• original halogen light

• fish tape on the drivers side

• wiring tidied up before replacing the center console trim

• wiring

• behind the drivers side dash wiring

• drivers side wiring

• driverside location

• passenger side wiring done and secured with cable ties

• plug holder cover back on and cable tie replaced

• wire in and fixed up with some electrical tape

• end to fit into position 72, the pin must be in the correct orientation before you push it home. this is critical

• leave enough slack for the seat to go back and forward and tie it to the existing seatbelt wiring to keep it from catching

• same gain

• more wiring

• feeding the wiring through under the seat

• cutout

• cutout for the rear light under the bottom of the passenger seat

• back of the passenger seat

• feed the wire under and out below the seat

• fishtape and light clip

• hole in the carpet where the wiring should pass alongside the seatbelt pretensioner wiring

• fish tape under the seat rail on the passenger side

• driver wiring

• other side of the console pull the wiring through to feed the driver front and rear light

• the centre console

• run the wire to the other side of the dash

• run the wire under the deadening

• wiring for the passenger light

• routing the rear passenger side light

• plug location

• Pin 72

• VCDS coding

• halogen light

• 20171210_170659.jpg

• Passenger light location