35North

Hi there Need to change rear brakes, but it says connent a battery charger, I have one but not a stop&start Capable, Question is would it be OK to use for a little bit to do the job or is it OK the turn on Ignition set open brakes then turn off ignition? Without the charger.

I been using Millers Diesel Power Ecomax 500ml and it been fine

Yea I had to reread before ordering, To many opinions to pick also I went through the reviews with pics to see what they ordered to see what infotainment they had

I have MQB-Cam A

I also have a rear cam and the boot cam both go through the right tailgate rubber. What I did was Squash is smaller than feed it through

Tools needed/what I used Trim Panel Removal 31pc car stereo keys (don't use the ones in the kit one of them got stuck) screwdriver bit T20 String/cable or telescopic magnetic Remove the multimedia in the glovebox, cut the cable tie at the back on the main loom to to get the unit out, Test the kit NOW before fitting it all in and then find out it does not work. then remove the trim on the floor and around the door frames to the boot. (you can go by the roof but you may block the side airbags deploy by the wire) remove the trim on the boot lid be careful of the boot light cables there will be 3 T20 screws 1 on the leather strap remove the bigger trim part and the other 2 are on the topside on the boot trim. Now I had to wire it on the offside (driver) boot grommet as the Nearside had a lot on cables already in it, to unclip the handle it from the outside of the boot then clip in your new camera in and wire it all up. the only time I use a cable/ telescopic magnetic to route the cable was on the nearside rear piler/ part of the roof liner and the boot lid and there is NO CODING just plug and play, hope that helps. I have just found out today though is when in reverse the nearside mirror is not dropping now but that not a big problem

Just fitted this rear camera from AliExpress, https://www.aliexpress.com/item/4000230897829.html?spm=a2g0o.order_list.order_list_main.11.79f21802B5duGe It just plug and play but do not use the car radio removal keys that come with it as one got stuck in the slot and was a plain to get out, Here is others that done it

2017 74k miles

You will need to use trim removal tools, for the front lights start at the front nearer to the windscreen and work around only the clear bit of plastic, as for the rear lights I had to remove the whole unit then pry the cover off to get the the bulbs at this point it was a bit of a struggle to get them out by hand but use a flat head screwdriver to help it out. I got this of ebay https://www.ebay.co.uk/itm/374038217284 If they don't work the 1st time turn the LED around. They are bright much better

I just replace the bulbs with LED's in the boot and lights inside with auxito w5w led lights of eBay, they are great sorry I did not take any pics but they are bright

Hi Is there an update for this one ? if so please can I have the Firmware & some instructions please Many thanks

I can't of top of my head but I found this, if this helps https://fuseandrelay.com/skoda/mk3-superb.html

I'm using the rear wiper fuse

I got mine from here https://www.ebay.co.uk/itm/182420564053?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649

How so you view the service history