stokie_nav

We picked up a brand new Kamiq SEL for the wife last week and if I am honest i think that the software is extremely buggy to a point of being useless. So far we have had the following issues: 1. Cannot make a user the 'primary user' - even though driving license confirmed with Skoda I get the error ‘Please try again or call customer service’ - every sinlge time i try - i have reset the head unit countless times and still no joy. 2. Gear suggestion suggest changin from 6th gear down to 1st whilst doing 70 MPH on the motorway! 3. Lane assist icon comes and goes from the "virtual cockpit" and i am pretty sure when its not there its not working. 4. Whenever I try and do anything to do with Skoda Connect in the car it takes 1-2 minutes for thinsg to happen and we are only half a mile from ee/voda/o2/three phone masts I cannot get a straight answer out the supplying dealer as to wether they have done all the software updates as part of the PDI - I seriously doubt they have as I am guessing Skoda will pay them to do updates so i will need to book the car in. Not a very happy bunny at the moment!

Hello, I have a 2017 L&K Combi (190bhp 4X4) and today the Engine Management light has come on. I plugged in my VCDS lead and cleared the fault but within 5 minutes its back... Whilst the car hasnt gone into limp mode, and there is nothing showing in the venicle part of the maxidot - the Fault Priority is 2 which, according to the VCDS manual, is a "The Fault requires an immediate service appointment" Has anyone else had this issue? Knowing my local garage its going to be at least a week before they will look at it and I have got to drive about 400 miles at the end of this week. 1 Fault Found: 28253 - Coolant Pump 3 P26F8 00 [175] - Stuck MIL ON - Confirmed - Tested Since Memory Clear Freeze Frame: Fault Status: 00000001 Fault Priority: 2 Fault Frequency: 1 Mileage: 69569 km Date: 2019.06.24 Time: 18:33:05 Engine speed: 0.00 /min Normed load value: 0.0 % Vehicle speed: 0 km/h Coolant temperature: 69 °C Intake air temperature: 66 °C Ambient air pressure: 990 mbar Voltage terminal 30: 11.520 V Unlearning counter according OBD: 40 Engine status: COENG_READY Engine status-Test_Program_Co Eng st COMPU VERB UBYTE: 1 Readiness: 1 1 0 0 1

Hi, I have a VCDS lead (HEX+CAN) that I am selling on ebay and a potential buyer has asked if its unlimited VIN version. I honestly cannot remember if there were options for limited vins when I bought it. Is there anyway of finding out in the VCDS software if the interface unlimited VIN? Or are all HEX+CAN lead unlimited VIN? Many Thanks in advance

The car is at the dealers at the moment and the service manager is taking it home tonight to see if he can get it to fault. If they dont get it to fault then I will be contacting skoda and asking for a loan car until its fixed!

Good Afternoon We took delivery of a new Kodiaq Scout TDI 4X4 about a month ago. Since the day we picked the car up we have been having issues with it occassionally stalling. It seems to be when decelerating (with the clutch still out), so approaching roundabouts and junctions etc. We have turned off the Stop-Start and it still happens. Unfortunately the dealer cannot find any fault with the car but its definately got a fault - it has done stalled when I have been driving and the wife notices it more (its her car) Has anyone else experienced this phenomenon?

Hello The little key that you use to open the car door if the fob is t working has fell out of my fob key . does anyone know if just this “dumb” door key is available as a spare from skoda or do they sting for a new complete fob with key and coding ? Many thanks lee

Got an email back from Rosstech asking me to download the beta version (even though enabled automatic download of beta versions in VCDS and it said that nothing was found??) Installed the Beta - did a scan - all works and allowed me to change the Power Trunk options which i wanted to do Kudos to Rosstech for the quick response

I have checked for latest versions (Including betas) and it says that there isnt any available. I have maiiled support @ rosstech to see if they can give some guidance

Just done a full scan and lots of the controllers are saying unsupported vehicle - Im on the latest version of VCDS (17.1.3 x64) so it looks like it doenst support the new Octavia yet :-( Do Rosstech need the scan results to help with their R&D ?

I had exactly that happen on my old Superb - Garage tried to charge me £80 to repair it - Dug my heals in and then Skoda agreed to pay half and the garage agreed to pay half. I genuainely hadnt knocked the thumbwheel and beleive it was a manufacturing fault If your car is still under warranty just dig your heals in :-)

I have taken delivery of a brand new Octavia 1.4TSI SEL today and have the optional power trunk fitted. Its really annoying that the only way to close it is to press the button on the boot lid so, as i have VCDS, i want to enable the closing of the boot using the Remote and Button on the dash but just wanted to check that plugging the VCDS into the facelifted vehicle wont have a detrimental effect.. The only reason for asking is that im sure that I read on one of the threads on briskoda that someone had taken delivery of a brand new car and scanning with VCDS removed all coding meaning that it had to be sent on a tow truck back to the dealer - and i dont want that to happen to me :-)

I have a my15 superb l&k dsg estate which is now awesome (after a new mechtronics pack after 3 months) There is 1 small issue I have with the sound system - as I drive along the bass is brilliant, as soon as I stop at a junction and the engine stops the bass noticeably reduces. I'm guessing it's turning the amp down to reduce battery drain when stationary - is there any way to stop this happening using vcds? It's really annoying if you are in stop start traffic!! Many thanks Lee

Picked up my car Wednesday morning and it's like driving a completely different car. The gear changes are now so smooth it's hard to tell when it's changing gear. The fuel economy is miles better as well, before the mechtronics pack was changed I struggled to get 40mpg - now, on one recent trip down the m6, I'm getting 55mpg. Can only assume that the pack has been faulty since the car was new - hopefully that's the last problem I'll have with it (fingers crossed)[emoji1]

Mechtronics arrived today - garage now decides need a gasket that they won't get until tomorrow. Car won't be ready until Tuesday - that 3 days short of a month it's been with them and I've been driving around in a Passat. On the plus side the Passat is averaging 60 mpg [emoji1]

Just got a call from Skoda - mechtronics pack not arrived yet - may arrive Friday - hope it sorts the problem !!