hey guys how and where do you put wiring through to wire in a amp etc ?

Have a look in the ICE forum and have a look at the posts that come up if you search for more detail, but basically, put the amp in the boot (or poss under driver's seat from memory - search) and run power through a rubber bung in bulkhead if VRS or drill a hole if not VRS, and run cables down the side trim by the doors. Speaker cable can be run back on the other side or through the transmission tunnel, all trim pops off easily or the centre console can be unscrewed with a torx ?T20 ?T25 bit.

Search for more info,

Hope that helps.

Rob

You don't need to drill anything on a VRS either.

Take the glove box out (5 screws)

Look up the firewall and you will see a hard plastic pipe going through a ruber grommet (Bonnet opening wire)

Pop the fused live wire through there (Might need to lubricate the wire to help it slide through, and use a small long screwdriver or straightened metal coathanger to pop through first, tape the wire to it, then pull it back through.)

You can tuck the wire between the carpet and plastic trim all the way back to the boot on the passengers side. No need to take trim off, just tuck it up with your fingers.

You can get your earth or negative from the boot itself so no need to run one from the battery. If you peel back the carpet from just under the left rear parcel shelf speaker (where the boot light is) you will see an earth point on the bodywork, just wip the 10mm nut off, pop your wire in, and tighten it back up, simples.

Then obviosly you just need to run your audio input wires/connector from head unit to amp, but im sure you will find a suitable route to run that. (possibly time to take that plastic trim off on the passengers side and run it propely.)