just got round to doing my grille in 3m carbon fibre over the weekend, but have a a little left so thought id do something inside the car, any ideas what ? thought about the long flat bits either side of the symphony and maybe a swith or 2..... got about a foot of the stuff left

cheers mm

Stick it across your face and pretend you're in Special Forces?

Air vents, that will start to break up the bland interior

that could be a good idea, might be awkward though

If you've done the grille successfully, you should be able to do the vents too. Just pop them out of the dash first...

when i say '' ive''..... i really mean me and [mostly my mate] have just done done my grille ..... might have a look though

Not that hard easier to do than the front grille

Example

Karl

cheers Karl, liking that a lot, never thought of the handle surrounds also

cheers mark

If you've done the grille successfully, you should be able to do the vents too. Just pop them out of the dash first...

how do they come out?

How about the bumper "vent" inserts on the side of the front bumper.

I'm after a small piece of Di-Noc to do mine.

I think it will make my already Di Noc'd grille look less lonely.

how much is this stuff

Enter Di Noc into the ebay search box,

Many sizes available, depends what you want to cover.

Make sure it's the genuine stuff made by 3M or you'll be disappointed.

Here's one I found earlier.

http://cgi.ebay.co.uk/GENUINE-3M-DI-NOC-CARBON-FIBRE-WRAP-VINYL-60-x-120cm-/180618050389?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item2a0dacbb55

That stuff looks the *******s! how easy is it to fit? what tools would i need to do a good job?

how do they come out?

http://briskoda.net/forums/topic/60566-dashboard-creak-fabia/

...same should apply to the ones at the sides. Otherwise all can be pushed out from behind if you take the bottom section of the dash out:

http://briskoda.net/forums/topic/112621-fabia-heater-air-con-control-panel-replacement-how-to-with-pics/

But I think this is probably a bit extreme!

How about the bumper "vent" inserts on the side of the front bumper.

I'm after a small piece of Di-Noc to do mine.

I think it will make my already Di Noc'd grille look less lonely.

Just the black bits or the whole lot

Mate you are just brimming with good ideas!

Might have to get the Hair dryer out tonight

Just the black bits or the whole lot

Mate you are just brimming with good ideas!

Might have to get the Hair dryer out tonight

I was going to cover the whole venty bit and trim it in with a craft

knife so it looks like a carbon insert. I've got a 1ft by 2ft piece in

the post as we speak.

Edited 7 February, 201115 yr by grr666

I was going to cover the whole venty bit and trim it in with a craft

knife so it looks like a carbon insert. I've got a 1ft by 2ft piece in

the post as we speak.

looking at it i was thinking of just the matte black bits of the fog light surrounds

The stuff is a pleasure to work with

oh now i know which bits you mean sorry its early

I think grr666 means like this

Pic not great but should give you an idea

Karl

I think grr666 means like this

Pic not great but should give you an idea

Karl

Indeed I do