Most of you out there will have an integrated bonnet pin switch as standard, but this was not included on all models including the classic. I was just wondering if anyone had fitted a bonnet pin switch and had any tips on a good location to put it? Due to the design of the engine bay area it looks difficult to get it anywhere within the seal. There are pre-existing holes near the headlights in the rain gutter but water and corrosion would probably make it a bad idea. The other location I was looking at was near the air intake duct and spacing it away from the seal with some washers.

Thanks in advance

Edited 6 March, 201115 yr by anewman

Slam panel is fine, but I always used a bracket to allow for better adjustment of the switches used.