No Weitec C spanners :-(

[mobz]

Anyone know if it's possible to adjust the coilovers without the C spanners?

The spring perch appears to be made of plastic so don't fancy damaging it.

Alternatively.......anyone local in Northampton have a set I can borrow please :-)

[DanHam]

Are you taking load off the coilover?

If it's stuck try and use some WD40 on it then give it a tap with a long piece of wood and a hammer or something like that

[mobz]

Ah thanks pal!

I'm not sure if it's stuck tbh, just didn't fancy attempting anything if I couldn't do it without the tools, but your suggestion sounds good :-)

I'm trying to raise the car approx 5mm, I assume I have to wind the coilovers down, towards the floor? Opposed to up towards the engine bay in order to lower the car?

[JoshH]

I have a weitec c spanner spare mate but not local so will need to post to you

[mobz]

How much you after pal (inc delivery)? Just to confirm, is it the ones with the rounded location points?

Cheers

[JoshH]

Will PM you a pic tomorrow when I go to my toolbox just cover postage and a padded envelope.

[mobz]

Top lad! Thanks mate, appreciate it!

[DanHam]

Ah thanks pal!

I'm not sure if it's stuck tbh, just didn't fancy attempting anything if I couldn't do it without the tools, but your suggestion sounds good :-)

I'm trying to raise the car approx 5mm, I assume I have to wind the coilovers down, towards the floor? Opposed to up towards the engine bay in order to lower the car?

To make the car higher you screw the adjusters upwards

[rover220]

I also have a suitable spanner if you struggle

[mobz]

To make the car higher you screw the adjusters upwards

Ahhhh I see! Thanks for confirming :-)

[mobz]

I also have a suitable spanner if you struggle

Sweet! Thanks, I'll let you know pal :-)