New design Lower intercooler inlet pipe to replace the Pancake pipe, old one was as restrictive as the pipe it replaced, this new one is about 57mm OD and seems to fit without any fouling problems ( albeit I run adsjutable droplinks) so that may have given slightly more clearance, just to be sure I ground the bolt ends of the droplinks flush with the nut surface.

On the road, it seems to have made a noticeable difference, certainly gives the engine note more of a growl, toque seems to be up a bit as well as wheel spin when booting it into second is increased slightly, off to sheffield tomorrow so will be able to report back with any problems if any.

BTW now only

NNNOOOOOOO!!!!! i have on these for sale! will let it go for