I do not know the name of this part but yesterday after washing and waxing my rapid I was doing the windscreen and at the bottom where the wipers sit (black slotted air intake grille, there are 2 end covers.  They have always been a bit of a sloppy fit.  Enough to say the one on the driver side came off, there is a clip that hods it in place however the double sided sticky tape that holds it in place is well and truly knackered. 

I intend to get one of those sticky pads used to hold number plates on however in the mean time I have blu taked it into place hoping it doesnt drop off as I drive

any one else noticed this or had it happen on their rapid?

I do not know the name of this part but yesterday after washing and waxing my rapid I was doing the windscreen and at the bottom where the wipers sit (black slotted air intake grille, there are 2 end covers. They have always been a bit of a sloppy fit. Enough to say the one on the driver side came off, there is a clip that hods it in place however the double sided sticky tape that holds it in place is well and truly knackered.

I intend to get one of those sticky pads used to hold number plates on however in the mean time I have blu taked it into place hoping it doesnt drop off as I drive

any one else noticed this or had it happen on their rapid?

Do you mean the little black rubber flap? One on either side? If you do one of mine is loose :(

yes them, I think they are purely decorative and to cover the A frame.  I was going to try some of these sticky pads you use to hold number plates on when not screwed in place.  When I get any that is.  The Blutak is working for now