Hi.

I am using this ODB2 interface.

http://itm.com.cn/member/209583_kklusbblue1.jpg

This is blue KKL USB adapter, that comes with CD to install chipset for USB <>Serial interface.

The problem is that I sucessfuly install USB interface (from CD), Add new hardware, start my Vag-COM point it to right port. It give me an error Port ok, interface not found. I do LED test it return ok..

Any ideas? Help...

THanks..

I forgot to state that I connect to my car, and turn the ignition key on.. Thanks..

What version of VAG-COM? And have you read the following FAQ page on Ross-Tech's site which discusses interface adaptors and VAG-COM software?

http://www.ross-tech.com/vag-com/faq_3.html

409.1

Try using version Version 311.2 - available below:

http://www.ross-tech.com/vag-com/download/archives.html

I use the same interface (AUTEL) as shown in the picture.

The error you mentioned is because you have not changed the com port in the USB software to be the same one that is used in the VAG-COM software.

When you change the port setting it will work.

It also works with VAG-COM version 4.09 software.

I think from memory that the port changing is under the advanced settings.

If you cannot find it, post again and I will check it out on my laptop.

Also see my post in this thread about the same problem:

http://www.briskoda.net/forums/diagnostics-vag-com/35715-no-response-controller.html

Hope this helps

Dougal

Hi...

I have changed virtual comport to 1, and pointed Vag-Com to that same port.. Thats why I get message Port ok, no interface. I am trying to use this cable on Vag-Com 4091 version. Should I downgrade it.. So I did configure my port to match on settings and vag-com, it must be something else.

I did some reaserch.. These blue cables are actialy have COM to USB internal adapter made by company FTDI.

http://www.ftdichip.com/FTDrivers.htm

This is same hardware used for original Vag-com cable. only difference is that they use dll to access USB, and this is spose to use virtual Comport to access USB..

What dirvers did you install. Was it from AUTEL page. I got some drivers on CD, and also update from FTDI page but no luck..

Please help, I am getting upsate that this does not work..

Thanks..

ok, here it is... port is set to 2.. vag-com is set to same port.. No go..

Any ideas..

When you tried to access the interface, did you have the interface plugged into the OBD socket in the car?

The power for the interface comes from the car OBD socket and there should be an LED glowing in the module when it is powered.

Also to access any modules in the car, the car ignition needs to be turned on.

Dougal

What I did just to test cable I hooked it up to Audi 1994 using 2x2 adapter cable to test the cable. DId not want to plug in unknow cable to new car. Tonight I am going to plug it in Fabia and see. Hope it works...

did you ever get this problem sorted mate i have the same problem any help would be great