I was investigating what mods to do when I get my OBDeleven and I wondered about one of the apps - Heated Seat Memory. I had the feeling my Pre-FL vRS230 did it anyway. I've actually paid some attention today whilst doing some stop/start driving and proved that it remembers for the heated seat setting for at least 10 mins after switching off BUT only on the drivers side. The passenger side switches off and stays off after switching off ignition. I think this is good setting as otherwise you may not be aware that the passenger seat was still on after a short stop in which the passenger disembarked. I don't know if there's an option to enable memory on the passenger side too but I'm happy with the way it works as it seems to be a sensible configuration as it is. I'll try and remember to check when doing longer stops to determine when the drivers side memory times out (2 hours maybe?)

 

Never

10 mins

Permanent

 

From memory, those are the options for heat level retention time. Both driver and passenger seats can be coded, separate of each other. 

I don't suppose there is a way to set the heat lower?  It's great but too hot to have on constantly.

After a few mins I want to turn it off even on the lowest setting.

1 hour ago, maul said:

I don't suppose there is a way to set the heat lower?  It's great but too hot to have on constantly.

After a few mins I want to turn it off even on the lowest setting.

I find the same - even on the lowest setting you can't leave them on too long - I don't like the griddled backside look